Table of Contents
Advertisement
Assembly (cont'd)
Handle and Valve (cont'd)
21. Place the piston with the seal in the tapered end
of the fixture and push it down and completely
through.
22. Install O-rings (24, 25) on seal body (26). Install
seal body and O-rings (24, 25, 26) in bottom end of
piston and rod assembly (20) and secure into place
with internal retaining ring (18).
23. Slide piston and rod assembly (20) in cylinder and
upper end assembly.
24. Screw handle assembly (1) onto cylinder (19). Seal
retainer (41) into end of the upper end (27). Thread
nut (68) onto upper end (27) approximately 25 mm
(1").
Greenlee / A Textron Company
Outer Extension Tube and Inner Pull Rod
1. Install pull rod (42) to piston assembly (20) with pin
(43) and secure with sleeve (44).
2. Slide outer tube assembly (45) over inner pull rod
(42) and screw onto upper actuator end (27). Thread
the jam nut (68) onto the outer tube (45). Refer to
"Closure Adjustment" in the " Maintenance" section
of this manual.
Cutter Head
1. Screw cutter mount (47) in end of outer extension
tube (45).
2. Fasten cutter hook (52) and cutter brace (55) to
opposing sides of cutter mount (47) with hex head
cap screws (62) and lock washers (61).
3. Position cutter blade (53) and washer (54) between
cutter hook (52) and cutter brace (55). Secure cutter
blade (53) with hex head shoulder bolt (57) and hex
nut (58).
Note: The cutter hook (52) and cutter blade (53)
must fit together snugly. If they are too tight, the
cutter will not perform properly. If the fit is too loose,
the tool will not cut cleanly and damage to the tool
may occur. Wood may jam in between the hook and
cutter blade, springing them apart and permanently
bending either one.
4. Install bolt lock (56) on cutter brace (55) and secure
with socket head cap screw (60) and lock washer
(59).
Note: If slot in bolt lock (56) does not align with
hole in cutter brace (55), turn bolt lock over. This will
allow bolt lock to be positioned so that slot will line
up with matching hole in the cutter brace, allowing
socket head cap screw (60) to secure it in place.
14
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
48520 Pruner
Advertisement
Table of Contents
