BEFORE CALLING FOR SERVICE
Before calling for service, please check the trouble shooting chart below.
It includes several common faults which you can correct, making a service call
unnecessary.
POSSIBLE CAUSE AND REMEDY
CIRCUMSTANCE
Cooler does not
Check if plugged in.
operate.
Check voltage. (It may be too high or low)
Cooling efficiency
Check if the machine is placed close to a heat source
is low.
or direct sunlight.
Check if the machine is placed too close to a wall.
Machine must be more than 4 inches from the wall.
Heating efficiency
Check turn hot water switch on at the rear side.
is low.
Is the machine placed on uneven floor?
Abnormal noise
Put the machine on firm and even surface.
ls there an obstacle at the back of the machine?
Remove the obstacle.
Drinking water does
Check if the water valve is on "open" position.
not flow well.
7.12.Z1 The specific instructions related to the safe operation of this
appliance (as given in 7.12 of this standard) shall be collated together
in the front section of the user instructions. The height of the characters,
measured on the capital letters, shall be at least 3 mm.
These instructions shall also be available in an alternative format, e.g. on
a website.
OWNER'S MANUAL
Please read this owner's manual thoroughly before operating
and keep it handy for reference at all times.
Point- Of-Use
Water Cooler
Model No. : YP-G10 (Hot & Cold Water)
YP-G1T (Hot & Cold Water)
YOUNG ONE Corporation