AirTech ATS-400B User Manual

APPROVAL
1. FCC Approval
FCC ID: ONKATS-400B
1) Safety Training Information
Your FM Handheld Transceiver
electromagnetic energy during transmit mode. This radio is
designed for and classified as "Controlled Exposure /
Occupation Environment", meaning it must be used only
during the course of employment by individuals aware of the
hazards, and the ways to minimize such hazards. This radio
is NOT intended for use by the "General Population /
Uncontrolled Environment.
This radio complies with FCC RF radiation exposure limits
set forth for a controlled environment. This radio should be
installed and operated with a minimum distance of 2.5
centimeters between the radio and your body. Therefore, to
ensure that your exposure to RF electromagnetic energy is
within the FCC allowable limits for occupational use, always
follow below information.
Do not operate the radio without a proper antenna as this
may damage the radio and may also cause you to exceed
FCC RF exposure limits. A proper antenna is the antenna
supplied with this radio by the manufacturer or an antenna
specifically authorized by the manufacturer for use with this
radio.
Do not transmit for more than 50% of total radio use time
("50% duty cycle"). Transmitting more than 50% of the time
can cause FCC RF exposure compliance requirements to be
exceeded.
generates RF
Always use Airtech supplied accessories (antennas, batteries,
belt clips, speaker/mics, etc.).
accessories can cause the FCC RF exposure compliance
requirements to be exceeded.
Always keep the antenna at least 2.5 cm (1 inch) away from
the body when transmitting and only use the belt-clips, when
attaching the radio to your belt, etc., to ensure FCC RF
exposure compliance requirements are not exceeded.
2) LABEL
This radio complies with the FCC
RF exposure limits for Occupational
Use Only.
3) This device complies with the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority
to operate the equipment.
Use of unauthorized
3