Connecting The Radome Scanner Inter-Unit Cable - Raymarine Pathfinder Radar Scanner Owner's Handbook Manual

24
Scanner base
You may need to use longer M8 mounting bolts to secure the scanner if you
have used shims to lower the radar beam.

Connecting the radome scanner inter-unit cable

CAUTION:
Before wiring the scanner unit, make sure that the inter-unit cable
is not connected and power is not applied to the display unit.
When you have run the inter-unit cable to the scanner location, connect the cable
as follows:
1. Loosen the 4 (18") or 7 (24") screws securing the scanner cover. These screws
are captive and should remain assembled to the lower flange assembly. Press
the radome inwards to release the top. This breaks the seal and makes
removal easier.
2. To avoid losing the scanner cover, tie the cord, attached to the inside of the
base of the scanner, to the moulded hole provided in the cover.
3. If you have a 24" scanner, unscrew and remove the inner cover:
Pathfinder Radar Scanners
Bitumen washer
Mounting bracket
or mounting surface
Greased mounting bolt
D3995-3