SpeechWare TableMike User Manual page 3

c) Note that NaturallySpeaking® may also display the following Error messages
ranges and conditions are not observed:
Note that you may also use
pressing the Normal / Sp. Rec. EQ button again (the LED turns Blue). In such a case, you must not only
but also Rerun General Training for maximum
menu and then select 'Check microphone...'. Whatever procedure you choose, NaturallySpeaking® will present
you with the following sequence of windows. Proceed like this:
a) First, NaturallySpeaking® will check your soundcards. If you only have one in your PC, you will not get
the first window because you do not need to make a selection. If you have more than one soundcard
installed, it will ask you to choose which one you wish to utilise. Select 'USB TableMike' and click 'Next'
in the first window. Position yourself within the recommended distance from the TableMike microphone
capsule (25 cm or 10") depending on your voice and ambient noise. Click 'Next' again:
b) Click the 'Start Volume Check' button and read the text until it turns grey.
and voice volume, making short pauses (3 to 5 seconds) at each punctuation
your voice and pauses (silence) will be properly sampled.
at the right hand side of the first window does not move or moves very little. After the text turns grey
again, click 'Next'. Repeat the previously outlined process in the second window by clicking 'Start
Quality Check' and then 'Finish':
To be sure that you get the most optimal signal-to-noise ratio, run the Check Microphone process in the environment
in which you will be dictating by dictating 'Check Audio'. That is, if you are going to be dictating into a low or
moderate noise environment,
changes during the course of the day, always rerun it again. Also, it is recommended that you rerun the process
periodically if you are continuously dictating for long periods of time because both your environment and voice
tend to change. This will ensure that your audio setup remains optimal.
your existing User Profile with the other 'Normal'or HD VoIP
be sure that you run it under those
accuracy. Open the existing User Profile, click in the 'Audio'
DO NOT SHOUT OR YELL
conditions. If your background environment
if the aforementioned
mode, available when
Calibrate
Read at your normal pace
sign. In this way, both
if the 'Gain' bar