Smokin Solutions Eco-Quartz Instructions Manual

Fault Finding
Fault Reason
The lights and Power is not
heater do not connected
work
The heater Tube is faulty
does not switch
on
Ambient
temperature is
above 20°C
Manual override
has been set
Heater and/or Manual override
lights do not has been set
switch
automatically
The lights do Light level is too
not switch on high (daylight)
A light is shining
on the sensor
The lights do Sensor is covered
not switch off or in a shaded
in daylight place
Manual override
has been set
Remote Control Light on remote
does not work does NOT come
on
Light on remote
does come on
ZN1020 Issue 2
Copyright © 2006 Sabring Ltd
Check Repair
Mains plug is not Reconnect plug
connected
Fuse in plug is Replace fuse (13A)
blown
Tube is correctly Check and replace
seated in the hold- tube if necessary
ers
Heater will only
turn on below 20°C
Switch back to Auto
using remote
control
Switch back to Auto
using remote
control
Lights will only turn
on at low light lev-
els
Sensor position Reposition sensor if
and other sources necessary
of light
Sensor position Reposition sensor if
necessary
Switch back to Auto
using remote
control
Battery not fitted Fit or replace bat-
or exhausted tery
Button press too Press button for a
short longer time.
16
Eco-Quartz Heater
Instruction Manual
Sabring Ltd
Unit 4, Moderna Business Park,
Mytholmroyd, HX7 5QQ
West Yorkshire, England
Tel: +44 (0) 1422 886888
Fax: +44 (0) 1422 886444
www.smokinsolutions.com