Wireless Pairing; Included Accessories - NAD HP70 Owner's Manual

INCLUDED ACCESSORIES

1 HEADPHONE ADAPTOR CABLE
For a complete listening experience on most devices not wirelessly
supported, use the standard ribbon cable. Plug the straight end of the
standard cable into the bottom of the right ear cup and the L-shaped end
into the 1/8" (3.5mm) stereo socket on your music player.
• Each ear cup is marked with "L" and "R" to indicate the left and right
sides of the headphones.
• A 1/4" (6.3mm) adaptor is also included for connecting to other
audio equipment.
NOTES
• Hold the plug at the end of the cable and pull to disconnect. Never pull
on the headphone cable to disconnect the headphones from the music
player.
• Turn the volume down to a comfortable listening level on your music
player before putting on VISO HP70.
2 AIRLINE ADAPTOR
•
Use the supplied dual 3.5mm airline adaptor to connect your VISO
HP70 to in-flight stereo entertainment systems.
NOTES
• The supplied conversion plug may not be usable depending on the type
of aircraft.
• Do not use these headphones when the use of electric devices on the
aircraft is prohibited, or when the use of personal headphones to listen
to on-board music service is prohibited.
• Audio output jack configurations may vary on airplanes. Airline audio
quality may not equal that of your home audio equipment, or portable
sources provide.
NAD recommends not to use these headphones as aviation
communication equipment. They are not engineered for many
environmental conditions common in commercial or non-commercial
aircraft (including, but not limited to: altitude, temperature, noise
conditions, unpressurized aircraft) and could result in possible
interference to critical communications.
4

WIRELESS PAIRING

3 USB CABLE
•
Use the supplied USB cable to listen to music from you computer
(audio only). This cable is used to charge your HP70 headphones.
Notes:
• When connecting the USB cable to the charging port, be sure to match
the cable connector with the shape of the socket. Forcing the connector
into the socket will cause damage.
• A rating of the charging output should be DC 5V, 2.4A or less
• -The usable time of the headphones differs depending on the
temperature of the environment in which they are used and method or
use.
Wireless Pairing
Pairing is the process required to create a link between Bluetooth devices
to allow wireless connection. You must pair a device with the HP70
headphones to be able to make a BLUETOOTH connection for the first time.
Before you start pairing operation, make sure that:
• The Bluetooth device is placed within 1 m (3 feet) of the headset.
• The HP70 is charged sufficiently.
To pair your device:
1. Turn on the Bluetooth feature on the source device.
2. Open the Bluetooth settings on the source device.
3. Press the pairing button for 3 seconds on the HP70. The LED will flash
BLUE.
4. Select the HP70 headphones from the device list.
5. Once the HP70's link has been established with the source device, the
LED will turn solid BLUE.
6. If pairing fails, the LED will turn solid RED.
NFC Wireless Pairing
HP70 supports Near Field Communication (NFC) so you can easily pair your
headphones. For pairing follow the instructions below.
To pair your device using NFC:
1. Turn on NFC and Bluetooth on the device you are pairing.
2. Place your Bluetooth enabled device against the bottom of the right
ear cup.
3. Accept the pairing on your device when prompted.
Note: NFC is a short-range wireless communication. Pairing devices
are required to be within a few centimetres of the headphones to
communicate. If pairing is unsuccessful, refer to the device's manual to
find its NFC touchpoint. Repeat the steps shown and ensure the located
touchpoint is placed against the right ear cup as directed in Step 2.