Yenista Optics Tunics Plus Quick Starting Manual

Quick Starting Guide
Tunics Plus
Tunics Purity
Tunics T100S
Tunable laser source

Unpacking and inspection

The Yenista Tunics Plus, Tunics Purity or Tunics T100
package consists of:
 The Tunics laser
 A set of keys
 A printed user manual
 A FC/APC to FC/PC optical patchcord
 An electrical outlet

Before You Start

Please note that the TUNICS lasers are a Class IIIb products (21 CFR Subchapter J)
equipped with a Remote Interlock connector (See the Auxiliary Inputs and Outputs section
of the user manual).
The laser sources are classified as class 1M according to
IEC 60825-1 (2001).

Getting started


Turn on the Tunics unit:
1. Make sure the key-lock switch on the front panel is in the Standby position.
2. Set the rear panel MAINS switch to ON (I).
3. Turn the front panel key to the right and set it to ON. During the initialization
routine, the message "Initializing..." is displayed.
4. The message "Referencing..." is then displayed to indicate that the system
performs its self-calibration (internal wavelength referencing). This message
clears once the laser is initialized and ready for operation.
5. Once the initialization routine is complete, the laser output is ready to enable.
The message "Disabled" is displayed.
6. The cavity laser is tuned automatically on its central emission wavelength
(depending on the model). The wavelength is displayed in the top window of
the DATA area (see Figure 1).
Tunics_Quick_Starting_Guide_2010-2510