Mpio HS 200 Manual

Table of Contents

1. Safety Precautions

3. Introduction & Specifications

4. Overview

STEP 1 Driver Installation

STEP 2 Data Storage

STEP 3 Removing HS200 From Your Computer

1. Safety Precautions

* You should be fully aware of the notice below, before using the product.

* The company does not take the responsibility for the defect of the product (accessory, connecting device

etc.), damage, data loss, accident & disorder etc., occurred from not fully understanding the notice below,

so please be sure to check this notice.

. Do not use the product for the other purpose except for the matters described in the manual.

. Pay attention not to hurt your hand while you touch a product box, manual, accessory etc.

. Hard disk is sensitive to impact. Pay attention not to have a severe impact on the product, might cause a

trouble or a damage.

. Pay attention not to use the device or leave it alone in places with high temperature and humidity or of

high thermal difference, and by the strong magnetic body.

. Remember that liquid (water, beverage etc.) not leaked into the device.

. The device that you discretionary disassembled or remodeled can not be provided with a free service and

can be excluded from the service areas, so pay special attention to this.

. The company shall not be held liable for data lost and damaged during data transmissions between

HS200 and your computer.

. Be sure to backup your data during data storage. Device malfunction, operational errors, external shock,

or power failure can cause loss of stored data. The company does not assume any liability for such

occurrences. Please take proper precaution

. Customers must back up the data stored in the device before requesting for the service. For the service-

requested device, the data are assumed to have been backed up by customers ; we do not provide any data

backup service separately. We assume no liability for any data loss during the service.

. Please plug or unplug the cable by holding the plugs not by pulling out the cable, to prevent internal line

breaking.

Table of Contents

Do you have a question about the HS 200 and is the answer not in the manual?

Page 1 Table of Contents 1. Safety Precautions 2. Composition 3. Introduction & Specifications 4. Overview 5. HS200 Using STEP 1 Driver Installation STEP 2 Data Storage STEP 3 Removing HS200 From Your Computer 6. Formatting 7. Troubleshooting 1. Safety Precautions * You should be fully aware of the notice below, before using the product. * The company does not take the responsibility for the defect of the product (accessory, connecting device etc.), damage, data loss, accident &...
Page 2 Do not give an impact to the connected part while the Computer is connected to the device. . When the device is covered with foreign particles, please wipe off it with soft cloth or clean towel and be careful not to use chemicals 2.
Page 3 4. HS200 Overview A. USB Terminal When connecting the device to the computer with a USB cable, connect terminal A of this cable to the USB terminal of the computer. Then insert the HS200 Body USB terminal into USB cable B. B.
Page 4 2. If you select “Safely Remove Hardware” the following message pops up. 3. When the window for the “Safely Remove Hardware” appears, select the “USB Mass Storage Device” in the window. This indicates the hardware device. Click the [Stop] button. 4.
Page 5 Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.