Gladen ONE 165 Golf 7 Installation Manual

Installation guide:
The following installation guide is only an example, because there are several different types of the Golf VII with
three or five doors or special edition, furthermore changes in the models as well. Thereby are a lot of variations
possible.

Security advice:

Only use this system with an
amplifier that is matched for this
speaker system.
Only assemble this system in this
Plug and Play version. Changes
or increments on the crossover
can cause damage to the

The Crossover:

All cable and clips are assembled, that the clips be used only with the pertinent speakers.
There is the possibility to affect the high-level area by cutting the cable loop on the side.
Important: after cutting these, please isolate them.
Cable loop 1
Series resistance 2,7 Ohm
before the crossover will be
activated after cutting
through
Possibility of error:
1. tweeter slightly to loud -> cut the blue cable
2. tweeter or voice sizzles -> cut the tranparent cable
RECOMMENDATION: Cutting through the blue cable on the drivers side and the transparent cable on the
passenger's side
GLADEN ONE 165 Golf 7
speaker or also can generate a
burning on the speaker.
Never use the speaker without
the crossover – they can be
damaged. This would void the
warranty.
Please consider all instructions
of the vehicle manufacturer and
never make changes, which
effect the vehicle safety.
Listen responsibly. Music played
too loud for extended periods
can cause hearing damage.
Cable loop 2
Series resistance 3,4
Ohm before the tweeter
will be activated after
cutting through