Advertisement
21-1806.fm Page 3 Thursday, August 5, 1999 2:35 PM
USING THE QUIET FEATURE
The quiet feature lets you talk and listen to peo-
ple who are using other radios set to the same
channel and quiet code. This is like having a
sub-channel within a channel, giving you great-
er communication flexibility. When you set a qui-
et code (38 to choose from) and turn on this
feature, you can communicate with anyone who
has a radio set to the same channel and code.
1. Select a channel to add a code to.
2. Hold down
, then press
FUNC
QUIET
,
, and
appear on the display. The code number
appears instead of
already programmed with a code.
TX /RX
*
means transmit/receive
3. Repeatedly press
CHANNEL
you see the code number you want to
select.
4. Hold down
, then press
FUNC
to store the code.
PTT
Now, select a channel where you stored a code
QUIET
to use the quiet code.
display. Press
until
QUIET
to disable the quiet code on the selected chan-
nel. Press
again to re-enable it.
QUIET
To clear a quiet code from a channel, repeat
Steps 1–4, pressing
CHANNEL
3 until
appears.
To set one code for the transmit side of a chan-
nel and a different code for the receive side, re-
peat Steps 1–3 (select the receive code in Step
TONE
3) then press
.
STORE
pears. Press
again.
STORE
pears. Then repeatedly press
to select the transmit code, hold down
then press
.
STORE
6
.
STORE
TONE
TX /RX
*
if the channel is
or
until
or
STORE
appears on the
QUIET
disappears
or
in Step
/RX
ap-
TONE
TX
ap-
or
CHANNEL
,
FUNC
INSTALLING BATTERIES
Your radio uses four AA batteries for power.
You can use alkaline or rechargeable batteries.
(If you use rechargeable batteries, you must
charge them before you can use them in the ra-
dio).
Caution: Do not mix old and new batteries, dif-
ferent types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of dif-
ferent capacities.
Be sure the radio is off, then remove the battery
compartment as shown below. Slide the battery
holder in either direction and install the batteries
as indicated by the polarity symbols (+ and –)
inside the compartment.
(illus - show batteries being
installed in battery pack. Show
battery pack being removed from
radio (arrow pointing to removal latch).
Also show polarities on batteries/pack
and directions of travel of battery
retainer slide)
Slide the battery holder to the center of the bat-
tery compartment, then snap the battery com-
partment onto the radio.
3
Advertisement
