Optimus STAV-3780 Owner's Manual page 28

Using the Remote Control
28
CATV Brand
Jerrold 711,701,702,712,704,713,703,714,716,715
Pioneer 700
S.A. 705,706,708,709
Zenith 707,717,710
MD Brand
Denon 904
Kenwood 903
Pioneer 900
Sharp 902
Sony 901
2. While holding down
want to set. The PRESET RECALL indicator lights.
The labels on the
CONTROL MODE
only. You can program any device to any button. For example, if
you do not have a DVD player but you wish to program your sec-
ond VCR, use to enter the code for second VCR.
DVD
3. Point the remote control to the device desired and enter the three-
digit code. The remote control sends power on/off signal for the
device. If the code is correct, the device should turn on or off.
If the device does not function, repeat Steps 2 and 3 and try other
codes for the manufacturer. If it still does not function, you must
use the original remote control supplied with your device.
N N N N o o o o t t t t es es es es: : : :
• The remote control keeps the code you programmed for short peri-
ods of time, allowing you to replace the batteries without losing
the codes. However, if the remote control fails to operate after you
replace the batteries, re-enter the codes.
• You can clear all the programmed codes if necessary. Press
, and (on the top row, not
DISC POWER
at the same time for about three seconds until the PRESET
RECALL indicator blinks three times.
Code
Code
, press the button for the the device you
PRESET
buttons are for your convenience
RECEIVER POWER
,
PRESET
at the bottom)