Summary of Contents for Woodtek 143-009
-
Page 1: Instruction Manual
143-009 MidiLathe (16) 9/28/07 11:16 AM Page 1 INSTRUCTION MANUAL Midi Lathe • MODEL 143-009 1108 North Glenn Road, Casper, Wyoming 82601 1-800-645-9292 woodworker.com... -
Page 2: Warranty And Service
143-009 MidiLathe (16) 9/28/07 11:16 AM Page 2 WARRANTY AND SERVICE SCHEMATIC – WOODTEK ® LATHE DUPLICATOR Woodworker's Supply ® , Inc., warrants all machinery and accessory components for a period of 12 months from the date of delivery and will replace any products which in normal use have proven to be defective in materials or workmanship. -
Page 3: Table Of Contents
143-009 MidiLathe (16) 9/28/07 11:16 AM Page 3 TABLE OF CONTENTS Warranty and Service ......... .2 Table of Contents . -
Page 4: Warnings
143-009 MidiLathe (16) 9/28/07 11:16 AM Page 4 TROUBLESHOOTING WARNINGS PROBLEM POSSIBLE CAUSE SOLUTION 1. Read and understand the entire Instruction continuing operation. Manual before attempting assembly or 27. Always turn machines off before cleaning. No power 1. Fuse blown or circuit breaker 1. -
Page 5: Specifications
143-009 MidiLathe (16) 9/28/07 11:16 AM Page 5 Bowl Turning SPECIFICATIONS Preview dry. This may take several weeks or months Motor ........1/2HP, 115VAC, 5A, 1720 RPM There are many different turning accessories used depending on how wet the wood is. -
Page 6: Installation
3- Define the ends of the cove by marking the Unpacking The Woodtek Midi Lathe comes completely assembled in the packing crate. Prior to unpacking, make a 1- Wood selected for spindle turning should be spindle with a pencil while the workpiece is note of any damage to the packing crate. -
Page 7: Basic Components
143-009 MidiLathe (16) 9/28/07 11:16 AM Page 7 OPERATION BASIC COMPONENTS Turning Tools Caution Gouges Many books, videos and workshops are available on the subject of woodturning. Before turning on this lathe, prior Scrapers experience in woodturning is recommended. The information below is... -
Page 8: Introduction
Pulley Drive Speeds can be quickly changed on the Woodtek Midi Lathe. First ensure that the lathe is turned off and the unit is unplugged. Open the headstock cover and then open the belt access cover on the rear of the headstock by pulling the knob out and up and lowering the cover plate Fig.
Need help?
Do you have a question about the 143-009 and is the answer not in the manual?
Questions and answers