Portable bassinet 'n cradle with toybox base (10 pages)
Summary of Contents for Badger Basket 02240
Page 1
SLEIGH STYLE BABY CHANGING TABLE WITH DRAWER MODEL NUMBERS: 02240 - White 02241 - Natural 02242 - Cherry Assembly Instructions. Adult Assembly Required. Save these instructions for future use. Visit us online at www.badgerbasket.com Toll-Free Customer Service: 1-800-236-1310 (Monday through Thursday 7:30 AM to 4:30 PM CST) Web: http://www.badgerbasket.com/parts •...
READ ALL INSTRUCTIONS before use of this changing table. Keep instructions for future use. Choking Hazard! Keep unassembled parts out of the reach of small children. Use only the parts, hardware, and changing pad provided by Badger Basket. Do not use the changing table if it is damaged or broken.
PARTS AND HARDWARE: TOOLS NEEDED (not included): Phillips Screwdriver Standard Screwdriver Power driver is helpful but be careful not to damage the product. TABLE PARTS INCLUDED: ASSEMBLY NOTES: (A1) 1 - Right Outside Drawer Track Parts & Hardware diagrams not to scale. (A2) 1 - Left Outside Drawer Track (B1) 1 - Right End Panel * Style of PEGS may vary from shown...
Page 4
STEP 1 - PICTURE 1: Attach the TWO OUTSIDE DRAWER TRACKS (A1 and A2) to the TWO END PANELS (B1, B2) using SIX ½” SCREWS (C) (three screws for each track). Line up the first hole behind the track wheel so that all three screw holes on (B) match up to holes on (A), and the narrower end of (A) lines up with the end of the track board.
Page 5
*You must be sure to use the thicker H1 PICTURE 6 shelf in the top PICTURE 5 position. STEP 6 - PICTURE 6: Attach the SECOND END PANEL (B1) to the TWO TOP RAILS (E) and SIX SHELF RAILS (F1, F2) using EIGHT 1¾” BOLTS (G). STEP 7 - PICTURES 7A, 7B and 7C: Note: This step can also be completed with the table upside down to make it easier.
Page 6
STEP 9 - PICTURE 9: Insert the METAL PINS (M), and the wooden pegs, on the LEFT (N) and RIGHT SIDE PANELS (O) into the holes on the side edges of the BACK PANEL (P). Be sure all of the shelf grooves are lined up. Insert TWO ROUND METAL CAMS (Q) into the holes on the BACK PANEL (P) with the arrows on the cams pointing towards the heads of the metal pins.