THUNDER TIGER TTR-SB Seawolf Instruction Manual

Submarine

Hide thumbs

Table Of Contents

Quick Links

No.5222-F

Please read all instructions thoroughly before operation.

For fresh water use only.

The contents are subject to change without prior notice due to product improvements and specification changes.

Thunder Tiger Corporation guarantees this model kit to be free from defects in both material and workmanship. The

total monetary value under warranty will in no case exceed the cost of the original kit purchased. This warranty does

not cover any components damaged by use or modification. Part or parts missing from this model must be reported

within 60 days of purchase. No part or parts will be sent under warranty without proof of purchase. To receive part or

parts under warranty, the service center must receive a proof of purchase and/or the defective part or parts. Should

you find a defective or missing part, contact the authorized Thunder Tiger Service/Distributor nearest you. Under no

circumstances can a dealer or distributor accept return if assembly has started.

Table of Contents

Need help?

Do you have a question about the TTR-SB Seawolf and is the answer not in the manual?

Questions and answers

Summary of Contents for THUNDER TIGER TTR-SB Seawolf

Page 1 The contents are subject to change without prior notice due to product improvements and specification changes. Thunder Tiger Corporation guarantees this model kit to be free from defects in both material and workmanship. The total monetary value under warranty will in no case exceed the cost of the original kit purchased. This warranty does not cover any components damaged by use or modification.
Page 2: Table Of Contents
INTRODUCTION Thank you for your purchase of the TTR Seawolf submarine. The Seawolf submarine is the 1st underwater R/C model by TTR. Equipped with high technology operating system in the inner hull tube, covered by bright orange color outer hull, the Seawolf will let you enjoy the underwater world.
Page 3: Items & Tools Requirement
ITEMS & TOOLS REQUIREMENT RADIO SET For 40MHz 8603S Seawolf Commander For 75MHz TOOLS Lexan Cutter/ Needle Nose Pliers NEEDED FOR Scissors ASSEMBLY Phillips type screwdrivers & hex wrenches Wire Cutter Thread Locking Glue TOOLS INCLUDED IN Hex Wrench Wrench 4-way Cross Wrench 5-way Nut Wrench IMPORTANT NOTES &...
Page 4: Configuration
CONFIGURATION Switch-Power On Verticle Stabilizer Switch-Not in Used Rudder Charging Plug Propeller Front Elevator Water Inlet/Outlet hole Rear Elevator...
Page 5: Radio Control Vs Submarine Movement
RADIO CONTROL vs SUBMARINE MOVEMENT Forward Backward Throttle Note: Drive of water pump. Floating / Diving Draw water for diving. Drain water for floating. Right turn Steering Left turn (Forward) Nose up Elevator Nose down (Forward) 1) The radio show in the drawing is similar to Mode 2 of RC airplanes: throttle is at the left stick and elevator is at the right one.
Page 6: Introduction For The Main Device
INTRODUCTION FOR THE MAIN DEVICE LED INDICATION LIGHT On the main control PCB unit, there are 3 LED lights are designed to show the current status of the Seawolf submarine. You can observe the light and refer to the following chart to get the light information. Light Sign Seawolf Status Light Sign...
Page 7: Operation
OPERATION For fresh water use only. Power Switch POWER SWITCH The main power switch is located at the bottom of the front flange. From the bottom view, the left switch is to control the main battery power for all the electric devices. The right switch is unused.
Page 8 OPERATION BUOYANCY CHECK & WEIGHT ADJUSTING Before using the submarine for the first time, check its correct buoyancy. Fill a bath tub with cold water and put the submarine into it With the ballast bag completely empty, the submarine should float keeping the turret and a thin part of the outer hull above the waterline.
Page 9 OPERATION OPERATION All the controls are described above. Rudder and throttle functions are similar to other R/C models. This submarine is capable to perform both static and dynamic dive. For a full static dive, keep the motor idle and start the pump flooding the bag. You will see the waterline at the turret become higher and higher until the entire submarine will be submerged and will go down vertically to the bottom.
Page 10: Charger Connection
Luxembourg, Austria, Italy Distributed by : Thunder Tiger Corporation Distributed by / Vertrieb : No.7 6th Road, Industry Park, THUNDER TIGER EUROPE GmbH, Taichung, Taiwan 40755 Rudolf-Diesel-Str. 1, 86453 Dasing, Germany For customer service please contact For customer service please contact service@thundertiger.com...
Page 11 External & Body Assembly PJ6414 PJ6414 PJ6414 PJ6413 PJ6410 PJ6410 PD0888-S PJ6414 PJ6415 PJ6133 PJ6413 PD0889-S PD7811-S PJ6409 PD0889-S PJ6413 PD7814 PD7818 PJ6124 PJ6161 PD0889-S PD7814 PD7824 PD7811-S PJ6162 PJ6408 PJ6170 PD7808 PD0889-S *Camera and case are not included. PJ6162 PD7818 PJ6161 PD6419...
Page 12 Front Flange Unit Assembly Rear Cone Assembly PD7803 PJ6411 PJ6106 PJ6106 PJ6155 PJ6155 PJ6165 PJ6142 PJ6140 PJ6411 PD7804 PJ6412 PJ6416 PD7816 PJ6178 PD7815 PJ6411 PJ6412 PJ6101 PJ6120 PD7802 PD7825 PJ6411 PJ6116 PJ6175 PJ6104 PJ6411 PJ6120 PJ6156 PD7820 PD7801 PJ6412 PJ6413 PJ6179 PJ6172 PJ6101...
Page 13 Inner Structure Assembly Drive System Assembly PJ6400 8901 2853 PJ6403 PJ6403 PJ6403 PJ6399 PJ6403 PJ6402 PJ6402 PJ6404 PJ6404 PJ6402 Pump & Ballast Assembly Outer Ring Frame Assembly...
Page 14: Spare Parts
SPARE PARTS PJ6101 SEALED BOLT PJ6102 CONE RUBBER PJ6103 SWITCH LINKAGE ROD PJ6104 CONTROL LINKAGE ROD PJ6105 WATER INLET BOLT SET PJ6106 WATER PROOF BOLT SET PJ6107 MOTOR SET,550 PJ6108 ROLL PUMP UNIT PJ6109 MOTOR MOUNT PJ6110 BALLAST TANK PJ6111 WATER TUBE CONNECTOR PJ6114 DRIVE CUP&SHAFT SET PJ6115 PROP DRIVE SHAFT PJ6116 FR/RR FLANGE...
Page 15 SPARE PARTS PJ6146 PLASTIC TUBE(6),L60 PJ6147 PLASTIC TUBE(10),L30 PJ6148 PLASTIC TUBE(8),L2&L6 PJ6149 ALUM. TUBE(4),L150 PJ6150 ALUM. TUBE(2),L101 PJ6151 ALUM. TUBE(4),L96 PJ6152 ALUM. TUBE(2),L41 PJ6153 ALUM. TUBE(2),L38 PJ6155 RR ELEV. MOUNT TUBE PJ6156 HEX MOUNT BOLT PJ6157 WEIGHT MOUNT ROD PJ6159 WEIGHT/A,WT416G PJ6160 WEIGHT/B(2),WT740G PJ6161 ORING(2),Ø124MM PJ6162 ORING(2),Ø120MM...
Page 16 SPARE PARTS PJ6174 CONTROL PCB PJ6175 POWER DISTRIBUTION PJ6176 PRESSURE SENSOR PJ6177 LEAKAGE SENSOR PJ6179 WIRE CONNECT CABLE PJ6183 WEIGHT(4),WT120G BOARD PJ6399 PROPULSION MOTOR PJ6400 PROP. MOTOR MOUNT PJ6401 SERVO&H.W MOUNT PJ6402 ROUND FRAME SET PJ6403 SEMI-ROUND FRAME SET PJ6404 OUTER RING FRAME PJ6405 FR COVER PLATE PJ6406 FR MARINE CANOPY PJ6407 FR CABIN...
Page 17 SPARE PARTS PJ6417 5 BLADE PROP.,D62x40 PJ6418 FUSE HOLDER PJ6419 CAMERA BRACKET PJ6420 BATT. CONNECT WIRE PJ6421 WEIGHT/C(2),WT540G 2540S CHARGER,6S PD0889-S M3X10S (20) PD0975 Ø3 (20) PD1712-S M2.6X8S (20) For 40MHz PD7478 Ø6 (20) PD7809-S M2X8S (20) PD7819 Ø4 (20) PD7810-S M2X10S (20) PD7820 Ø9.5 (20) PD7811-S M3X12S (20)
Page 18: Spare Parts List
SPARE PARTS LIST PART# DESCRIPTION NOTE PART# DESCRIPTION NOTE PART# DESCRIPTION NOTE PJ6101 SEALED BOLT1 PJ6166 WATER TUBE,D6Xd3X300 PD0982 NYLON STRAP,2.5(SMALL,20) PJ6102 CONE RUBBER PJ6167 WATER TUBE,D7Xd4X220 PD1712-S BT P. TAP SCREW,M2.6X8S(20) PJ6103 SWITCH LINKAGE ROD PJ6168 BOTTOM PLATE PD7478 O-RING,Ø6(20) PJ6104 CONTROL LINKAGE ROD...
Page 20 This product and its contents may different from the graphics shown on this manual and are subject to change without prior notice due to product improvements and specification changes. Manufactured by : Thunder Tiger Corp.(Ningbo) 28 Jin-Feng Road, Liang Hui Industrial Park, Yuyao, Zhejiang JJ6212v2 thundertiger.com...

This manual is also suitable for:

5222-f