Page 1
Single Channel 6kW Studio Dimmer Instruction Manual Models: version 1.0 since 21 July 2017 ATTENTION! This instruction manual contains important information about the installation and the use of the equipment. Please read and follow these instructions carefully. Always ensure that the power to the equipment is disconnected before opening the equipment or commencing any maintenance work.
Page 2
It’s equipped with 400us Risetime choke which guarantee very low lamp noise. The other benefit of DP6 is option to use W-DMX inside which allows control device without DMX cable. Additionally DMX OUT connector will be as source of DMX signal for any other DMX equipment or color changer.
Page 3
Connect power power input and output load to the DP5. Via fader you can select the output value. This value is in LTP law with DMX input. For avoid changes via DMX please setup DIP switch #10 to the position of disabling DMX. LTP: Latest takes precedence: change of signal take controlling of output power.
Page 4
Rear panel description On rear panel are placed CEE32A/3p in/out connectors, fuse for protection of electronic and OUTPUT indication. ( 4 / 8)
Page 5
IMPORTANT INSTRUCTIONS: All safety and operating instructions should be read before the equipment is installed or operated. IMPORTANT SAFETY INFORMATIONS: The following general safety precautions have to be observed during all phases of operation, service, and repair of this equipment. Failure to comply with these precautions or with specific warning in this manual violates safety standards of design, manufacture, and intended use of this equipment.
Page 6
Name of producer: SRS Group s.r.o. Address of producer: Rybnicna 36/D, SK- 83106 Bratislava, Slovak Republic Declares that the product Name of product: Single channel dimming unit Type: DP6, DP6W Corresponds to the following product specifications: EN60065, resp. EN60950-1 EN55103-1:2009...
Need help?
Do you have a question about the DP6 and is the answer not in the manual?
Questions and answers