JVC KD-DV6108 Installation & Connection Manual page 4

D
Required connections for DVD playback /
AV1-IN
or /
AV2-INPUT
Rear side
KS-HP2
Cordless headphones (not supplied)
KV-MR9010
9-INCH WIDESCREEN
MONITOR (not supplied)
E
Connecting the external amplifiers /
You can connect amplifiers to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that
it can be controlled through this receiver.
• For amplifier only:
– Disconnect the speakers from this receiver, connect them to the amplifier. Leave the
speaker leads of this receiver unused.
– For KD-DV6108/KD-DV6105: The line output level of this receiver is kept high to maintain the hi-
fi sounds reproduced from this receiver. When connecting an external amplifier to this receiver,
turn down the gain control on the external amplifier to obtain the best performance from this
receiver.
Rear speakers
JVC Amplifier
Front speakers
Only for KD-DV6108/KD-DV6105
JVC Amplifier
F
Connecting the external components /
JVC CD changer /
• Refer also to page 39 of the INSTRUCTIONS.
External component /
Only for KD-DV5108/KD-DV5105
Set external input to "EXT IN" (See page 36 of the INSTRUCTIONS.)
KS-U57*
CD changer jack
Video cord (not supplied)
Stereo mini plug
RCA Pin plugs
When using JVC's KV-MR9010
and KS-HP2, connect using a
conversioncable of this type (not
supplied).
*
4
*
4
Only for KD-DV6108/KD-DV6105: To listen to disc playback sound while in Dual Zone operations (see page 32 of INSTRUCTIONS).
Remote lead/
Remote lead (Blue with white stripe)
JVC CD changer
8
External component
* 8
Line Input Adapter KS-U57 (not supplied for this receiver)
VIDEO OUT
*
2nd AUDIO OUT 1
Digital optical cable (not supplied)
Audio/video control amplifier or the decoder
compatible with the multichannel digital sources
* 4
Headphones (not supplied)
Y-connector (not supplied for this receiver) /
To the remote lead of other equipment or auto antenna if any
Only for KD-DV6108/KD-DV6105
JVC Amplifier
Front speakers
*
5
Signal cord (not supplied for this receiver)
*
7 Connecting cord supplied for your CD changer
CAUTION /
• Before connecting the CD changer, make sure that the receiver is turned off.
LINE IN
4
*
1
DIGITAL OUT
See "About sounds reproduced
through the rear terminals."
* 6 Firmly attach the ground wire to the
metallic body or to the chassis of the
Subwoofer
car—to the place not coated with paint
(if coated with paint, remove the paint
before attaching the wire). Failure
to do so may cause damage to the
receiver.
External component