ASTEL TT 808P Operating Instructions Manual

Video twisted-pair transmitter

Advertisement

TT 808P
VIDEO TWISTED-PAIR TRANSMITTER
OPERATING INSTRUCTIONS
v2.0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TT 808P and is the answer not in the manual?

Questions and answers

Summary of Contents for ASTEL TT 808P

  • Page 1 TT 808P VIDEO TWISTED-PAIR TRANSMITTER OPERATING INSTRUCTIONS v2.0...
  • Page 2: Table Of Contents

    CONTENTS Preface ............................... 3 Features ..............................3 Block diagram............................. 3 Principle of operation..........................3 Controls and connectors ..........................4 Connections ............................... 5 Installation ..............................5 Appearance ..............................6 Specifications ............................. 6 SAFETY PRECAUTIONS In order to prevent any fatal accidents caused by misoperation or mishandling of the video twisted- WARNING: pair transmitter, be fully aware of all the following...
  • Page 3: Preface

    PREFACE PRECAUTIONS • Use only the power source specified on the The video twisted-pair transmitter TT 808P is a eight-channel correction amplifier with eight rating label located on rear of the cabinet. • When not using this unit for a long period of...
  • Page 4: Controls And Connectors

    CONTROLS AND CONNECTORS FRONT PANEL (1) PRE-EMPHASIS (2) POWER DIP switches to switch on/off the pre-emphasis of Switch to turn the power on/off - lights in the power the output video signals. on position. REAR PANEL 100-240 VAC 50-60Hz 40W (1) POWER SUPPLY (3) VIDEO INPUTS 1-8 Power cord.
  • Page 5: Connections

    CONNECTIONS • Be sure to switch-off the power supply unit before connecting to other equipment. • Also refer to the instruction manual of the equipment to be connected. VIDEO VIDEO VIDEO TWISTED-PAIR TWISTED-PAIR TWISTED-PAIR RECEIVER RECEIVER RECEIVER 100-240 VAC 50-60Hz 40W AC MAINS...
  • Page 6: Installation

    INSTALLATION The unit is suitable to use CAT 5 or other UTP (Unshielded Twisted Pair) cables, where is possible to connect one or more units and enable to pass more than one video signal through the same cable. (1) Connect the power plug. (2) Connect the video test generator (1 Vpp / 75 Ω) to the BNC video input connector.
  • Page 7: Specifications

    Model TT 404 TT 404P TT 808 TT 808P TT 1616 TT 1616P TR 101 1600 1600 1600 1600 1600 1600 1500 1500 1500 1500 1500 1500 TR 101L 1500 1500 1500 1500 1500 1500 TR 101LS 1600 1600 1600...
  • Page 8 ASTEL d.o.o., Dutovlje 138, 6221 Dutovlje, Slovenia Tel: +386 5 7310771, +386 5 7310772 Fax:+386 5 7310789 E-mail: sales@astel-cctv.com Web: www.astel-cctv.com...

Table of Contents