W&T Introduction Introduction Technology is unthinkable today without the USB interface. Even in industry the USB is gaining in significance. Accordin- gly, W&T has developed an industry-compatible USB hub. The „W&T USB -HUB Industry“ differs from commercial office USB hubs in that the device is housed in a DIN rail enclosure. In addition, the hub requires the industry standard voltage of 24 - 48V DC and can be used in an extended temperature range of from 0 - 70 °C.
W&T Introduction Overview • Meets USB 2.0 Specifikation • Downward compatible with USB 1.0 Specification • Data rates: 1.5 / 12 / 480 Mbit/s • Plug & Play • Operating system neutral (no driver required) • Protected against over-current/short-circuit • One status indicator per port •...
W&T Installation Mounting The housing of the W&T USB Hub and the arrangement of the vent. Especially in ambient operating conditions with elevated ambient temperature you must provide for adequate air circulation when using alternate mounting solutions.
W&T Installation Installation 1. Connect the USB-Hub to a 24-48V DC power supply using the provided screw terminal. (Power LED is green) Power supply 24-48V DC Screw terminal USB Uplink When connecting DC power supplies, please observe polarity as indicated on the screw terminal adapter: 24-48V DC If you are using the W&T power supply, screw the power supply connector on to the screw terminal adapter:...
Page 8
W&T Installation 2. Plug the USB cable provided to the USB-B plug on the side of the USB-Hub and connect the USB-A plug on the cable to the computer. 3. The operating system detects a new USB device and installes a new standard USB-Hub without asking for a driver.
Page 9
W&T Display Elements 4. Plug a USB device into one of the four USB ports on the front side of the USB-Hub. The asociated driver is installed and the USB device is ready to use. USB-Stick Power Uplink Irrtum und Änderung vorbehalten...
W&T Installation Display Elements Power LED No power Green Power OK Uplink Speed LED Fullspeed (FS) Device connected, max. speed 12 Mbit/s Green Highspeed (HS) Device connected, max. Speed 480 Mbit/s Port status LEDs (FS / LS) No device connected or device not ready Yellow Lowspeed (LS) device...
W&T Technical Data Technical Data Upstream ports (USB-B) Downstream ports (USB-A) Power supply mode External with power supply Power supply DC 24V .. 48V (+/-10%) Port supply DC 5V / 500 mA No-load current typ. 30 mA @24V Max. current draw 480 mA @24V Operating temperatures Storage...