Hitachi WF 4DY Handling Instructions Manual page 36

English
(2) In case that you use a screw which has a length
of 35-41 mm (L), please use the top adjuster No.
2 (large).
Top adjuster
Stopper Knob
No. 2 (large)
Fig. 10
[Fine adjustment of tightening depth]
The tightening depth adjustments (1) to (2) mentioned
above are just preliminary.
Perform fine adjustment after trial driving.
Rotate the knob in
is too high.
Rotate the knob in
is too low.
(Refer to Fig. 11)
Correct Too high
(Flush)
COLLATED SCREW STRIPS INSTALLATION
AND REMOVAL
1. Installation
(1) Insert the tape tip of collated screw strips into the
belt guide groove (A section).
(2) Next, insert the tape tip into the slider groove (B
section) and feed to push in the \ direction.
(Fig. 12, Fig. 13 and Fig. 15)
(3) Set the collated tape so that the first screw is lined
up with the slider screw mark. (Fig. 14 and Fig. 15).
35
Match the
stopper to the
screw length
(35–41).
direction when the screw head
direction when the screw head
Too low
Fig. 11
Slider
B section
A section
Belt guide
Collated screw
strips
(View from under)
Fig. 12
Set one screw
forward.
(View from front)
Screw mark
30°
1 screw forward
NOTE:
If the tape is not set as shown in the figure, the
bit can damage the board surface (inadequate feed)
and screws can be wasted (excess feed).
2. Removal
When the screws on the tape run out or to remove
a half used belt of screws, pull the tape out in the
\ direction as shown in Fig. 16.
Collated screw
strips
Top adjuster
Fig. 16
Fig. 13
Slider
Screw
in position
Fig. 14
Fig. 15