Table of Contents
Advertisement
The Basics
presetting audio input sources
Before mixing your audio sources (devices connected to
LINE 1, PHONO 1, PHONO 2, LINE 2, LINE 3, LINE 4), you must set their
input signal level to each channel input (CH1, CH2, CH3). You do
not have to mix every connected input source.
1. To preset the PHONO 1 input source, set PHONO 1/LINE 1 to
PHONO 1.
2. Play the selected input source.
3. Adjust the volume on your headphones or receiver to a
comfortable listening level.
4. Slowly adjust CH1 until you get a reading of up to 0 on the
mixer's LED meters.
5. Stop playback of the selected input source.
6. Repeat steps 2-5 to preset LINE 1 to CH 1, PHONO 2 and LINE 2
to CH 2, and LINE 3 and LINE 4 to CH 3.
The mixer's LED meters show total stereo output level. For best
results, input signal levels should be set so the meters read 0db or less.
PHONO 1/LINE 1
PHONO 2/LINE 2
CH 1
CH 2
10
LINE 3/LINE 4
CH 3
Hide quick links:
Advertisement
Table of Contents
