Hisense LCD19W57DCA User Manual page 16

Using the Remote Control
Quick starts
■ Selecting the picture mode
To select a picture mode:
Press [Picture] one or more times to select the picture mode you want. You can select
as Bright, Standard, Soft and User. This mode achieves a certain image display effect
by setting the brightness, contrast and color etc.
■ Selecting the aspect ratio
For the various Sources, this unit has set various display modes. Press Zoom button
to display Zoom menu, and then press [∧/∨] button to select the proper display
mode, including ''Auto", ''Full Screen", "Normal", "Zoom 1", "Zoom 2", "Smart
Zoom","Dot to dot". Finally press[＞/OK] button to confirm the selected display mode.
◇ Full Screen: This mode display the picture of input source expanded to fill the
screen.
◇ Normal Mode: Shows the standard 4:3 ratio picture image in the center of the TV
with dark bars on the left and right.
◇ Zoom1: Proportionally stretches the TV picture, but clips the top and bottom of the
image to fit the screen. Eliminates black bars.
◇ Zoom2: Zooms further into the middle of the screen and clips off more from the top
and bottom.
◇ Smart Zoom: Similar to 16:9 mode, but shows more of the horizontal sides and clips
off a little from the top and bottom.
◇ Dot to dot: Display 1:1 ratio pixel on the TV set from the source signal, without
stretching or compression the original signal.
Note: The option of zoom mode is different in different sources.
■ Freezing a picture
To freeze a picture:
Press [Still] repeatedly to access or quit Freeze.
■ Setting the sleep timer
You can specify the amount of time you want your TV to wait before it automatically
turns off.
To set the sleep timer:
ŸPress [Sleep] one or more times until the remaining time you want appears. You can
select Off, 10 minutes, 20 minutes, 30 minutes, 40 minutes, 50 minutes, 60 minutes,70
minutes, 80 minutes, 90 minutes, 100 minutes,110 minutes, 120 minutes. You can
also setup sleep timer in the time submenu.
15