Preparation; Charging The Battery Pack - Radio Shack MTX-103 Owner's Manual

19-1004.fm Page 5 Tuesday, August 3, 1999 9:11 AM

PREPARATION

CHARGING THE
BATTERY PACK
The MTX-103 operates on a built-in re-
chargeable battery pack (supplied).
You must charge the battery pack with
the supplied battery charger before
you use it the first time and when BAT
lights steadily.
You can charge the battery pack while
it is detached from or while it is at-
tached to the transceiver.
To attach the battery pack, slide it onto
the transceiver until the latch clicks.
To remove the battery pack, push the
battery pack latch in the direction of the
arrow, then slide the battery pack off
the transceiver.
Follow these steps to charge the bat-
tery pack.
Caution: Do not use the transceiver
while the charger is connected.
1. If the battery pack is attached to
the transceiver, make sure
is turned fully counterclock-
UME
wise so the transceiver is off.
2. Pull out the
CHG PWR
the bottom of the battery pack.
Plug the charger's barrel plug into
the jack, then connect
CHG PWR
the charger to a standard AC out-
let.
Note: Charging time is 14 to 16 hours.
VOL-
jack plug on
5