Using Dual Watch; Replacing The Fuse - Radio Shack TRC521 CB Owner's Manual

To silence the alert tones, press
flashes until you switch to WX mode and listen to
WX/ALERT
the broadcast. Or press
PTT
stops flashing. Ô
WX/ALERT
To reduce the alert tone levels for subsequent alerts, hold
down for about two seconds while
ALERT TONE OFF
flashes. The tone stops and
WX/ALERT
slowly. If the radio receives a new weather alert, three
low-level, short beeps sound (regardless of alert type).
To listen to the weather when an alert is received, slide
to .
CB/WX WX WX/ALERT
U D W
SING UAL ATCH
You can set your radio to constantly monitor for emergency
(Channel 9) signals. If an emergency signal is received, the
CB radio automatically tunes to Channel 9 so you can hear
the broadcast. When finished, the radio returns to the
previous station. This feature only works in CB mode.
To activate dual watch, press
lights. Press
DUAL WATCH
R F
EPLACING THE USE
The CB's in-line fuse protects it from power surges and
short circuits. When replacement is required, use a 2-amp,
fast-acting glass fuse, available at your local RadioShack
store.
1. Make sure the vehicle and CB are turned off.
2. Hold the fuse holder at both ends, push the ends
together, twist one end counterclockwise, and pull them
apart.
Fuse Holders
3. Remove the old fuse and inspect its condition. If it is
blown, insert a new one of the same type and rating. If
it is not blown, reinsert it.
4. Push the fuse holder ends together and twist one end
clockwise.
ALERT TONE OFF
to silence the alert tones so
WX/ALERT
turns off.
.
DUAL WATCH DUAL WATCH
again to deactivate.
Fuse
.
Ô
You cannot transmit while
WX/ALERT flashes in CB mode.
flashes
CAUTION
Do not use a fuse with ratings
other than those specified here.
Doing so will make your CB
susceptible to electrical damage.
Ô
NOTE
11