At Command - M-Labs APOLLO series User Manual

 Power cycle
 Watchdog timeout
 Reset command
 CDMA phone call reset
 SMS or UART power mode command
 Motion detect (if detector installed and enabled)
When in a power down mode, the following resources will cause interrupts that will wake the
Apollo series and cause them to attempt complete the function associated with the interrupt.
Simultaneous interrupts will cause sequential completion of each associated function. These
interrupts include:
 Re port t ime r
 GPIO change
 Bat t e ry t hre shold
 He art be at
 Wat chdog
 Power-up
The related interrupt function will be attempted for a total duration set the associated parameter
in the power mode command.

4.4 AT Command

Apollo series commands are AT extensions specific to Apollo series devices. They are closely
based on commands that are as similar as possible to other industry common devices and are
essentially subsets of standard Apollo commands. Common commands used with CDMA
modems supporting IP connectivity are not included within the Apollo series commands set
extensions. These commands are left in their native structure, as defined by the respective
baseband CDMA chip supplier which product already in use.
Command Summary
The following commands are highly specialized to the Apollo series. The commands listed
are intended to be similar to counterparts found in common CDMA modem command
extension.
1. AT+IONAA: Set append mode
2. AT+IONACK: Set acknowledgement mode
3. AT+IONAPN: Set APN
4. AT+IONBIN: Read the factory core software version (read only)
5. AT+IONBZ: Buzzer setting
6. AT+IONCV: Configuration version
7. AT+IONDI: Set distance interval interrupt