Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for A&D XL-25ANT
- Page 1 XL-25ANT...
- Page 2 A&D Medical eHealth wireless activity monitor Instruction Manual Thank you for selecting the A&D Medical wireless activity monitor. This activity monitor uses advanced sensor technology to detect steps in any dimension it is carried. It can be worn on the waist, around the neck or placed in pockets and handbags by using the adjustable strap or detachable clip provided.
-
Page 3: Lcd Screen
LCD Screen : Calories burned is displayed : Beep tone is Off : Battery power is low Displays mode banners, number of steps, calorie reading or distance walked : Alarm is On : Exercise timer is displayed : The number of days (1-7) before, the displayed data was recorded / / / : 12 hour clock... -
Page 4: Getting Started
Press and hold any key until the screen is activated. Carrying the activity monitor: The XL-25ANT can be carried on the waist, around the neck or in pockets and handbags by using the adjustable strap or detachable clip provided. If the activity monitor is idle for over 4 seconds, it will display the counted steps after 16 continuous steps have been taken. -
Page 5: Operation Mode
NOTE: Remember to set the time and your user data after every battery replacement. Operation Mode The XL-25ANT has 4 modes of operation. The Main Mode is the default display mode, which displays the current step count and time. To enter other modes, press the buttons as shown below. - Page 6 To view the current calories burned and distance walked: Press DISP. The display sequence is: calories burned and distance walked . The exercise time with icon is also displayed. To turn the step counter On or Off: In situations where you do not need to record step count, you can turn Off the step counter.
-
Page 7: Memory Mode
1. Press SET to enter the Setting Mode. 2. Wait for the setting option to flash, then press DISP or MEM to set values. You can press and hold these buttons to rapidly set the values. 3. Wait 3 seconds for the activity monitor to automatically confirm and move to the next setting option. -
Page 8: Battery Replacement
Please refer to the ANT receiver for more detailed instructions on linking the scale to the receiver. Battery Replacement The XL-25ANT uses a CR2032 3V battery, which has already been installed. Indicates battery power is low. To replace battery: 1. -
Page 9: Specifications
Specifications 12 / 24 format with hour / minute Real time clock 0 – 99,999 steps Step measurement range 0 – 99,999 km Distance measurement range (0 – 621 miles) 28 – 152 cm User adjustable stride length (11 – 60 inches) Calorie measurement range 0 –... - Page 10 Precautions To ensure you use your product correctly and safely, read these warnings and the entire user manual before using the product. • Use a soft, slightly damp cloth when wiping the device. Do not use abrasive or corrosive cleaning agents, as these may cause damage. Use lukewarm water and mild soap to clean the device thoroughly after each training session.
-
Page 11: One Year Warranty
NOTE: The technical specifications for this product and the contents of the instruction manual are subject to change without notice. One Year Warranty This XL-25ANT activity monitor is covered by a One Year Warranty. Contact Information: A&D Medical assumes no responsibility with regard to the use of these products. - Page 12 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. For more information regarding use, care or servicing of your XL-25ANT activity monitor, contact: A&D Medical A division of A&D Engineering, Inc.
Need help?
Do you have a question about the XL-25ANT and is the answer not in the manual?
Questions and answers