Hotpoint WLW3700B Use And Care Manual page 24

Hide thumbs Also See for WLW3700B:
Table of Contents

Advertisement

The Problem Solver
PROBLEM
HOLES,
SNAGS,
TEARS, RIPS
OR EXCESSIVE
WEAR
(continued)
.
HEAVILY SOILED
AREAS such as
collars and cuffs
WASHER WON'T
OPERATE
WATER
TEMPERATURE
IS INCORRE~
(continued)
POSSIBLE CAUSE AND REMEDY
. As Permanent Press garments age, they may show fraying at collars and cuffs. This is
normal due to weakening of fibers by the Permanent Press process. It is not caused by
washer. You can slow this process by washing small Permanent Press loads with a Full
Water Level. Do not wash heavy items such as towels with Permanent Press. Remove
collar stays, when possible.
spots if necessary.
May be caused by use of Normal/Fast Wash/Spin speed for delicate articles. Use
Gentle/Slow Wash/Spin speed. Refer to Garment Manufacturers' Care Labels.
Garments weakened by age, sun or atmosphere. This is inevitable and is not caused
by washer. Slow process by washing on Gentle/Slow Wash/Spin speed.
. Too large loads, or too little water. Load washer only with number of items that will
move freely. Select correct water level.
. Pretreat with liquid detergent.
. Make sure cord is plu~ed into outlet.
Make sure controls are set and cycie selector knob is pulled out to ON position.
. Make sure lid is closed. Washer will fi~ but will not spin or agitate with lid opn.
outlet, remove it. washer should have separate outiet.
. Make sure temperature selector controls are
properly set.
. Make sure hot and cold faucets am turned on
and regulated correctly.
Make sure hoses are connected to correct
faucets.. hot to hot, cold to cold.
Water valve screens may be stopped up. Remove iflet hoses from
water valve. Clean the screens and reinstil hoses.
o +

Advertisement

Table of Contents
loading

Table of Contents