Related Manuals for Duplo DC-6 Mini
Summary of Contents for Duplo DC-6 Mini
- Page 1 Duplo DC-6 Mini / DC-8 Mini Instruction Manual Provided By http://www.MyBinding.com http://www.MyBindingBlog.com...
- Page 2 DC-6 mini DC-8 mini Instruction Manual Please let our service people install the machine. @@@@@ AAAA PPPPP QQQQ @@@@@ AAAA PPPPP QQQQ PPPPP QQQQ @@@@@ AAAA PPPPP QQQQ QQQQQ RRRR AAAAA QQQQQ AAAAA QQQQQ QQQQQ...
- Page 4 SAFETY PRECAUTIONS Thank you for purchasing a DC-6 mini/DC-8 mini. This instruction manual describes the functions of the DC-6 mini/DC- 8 mini, how to operate it, and safety precautions in use. Before using your unit, read this instruction manual carefully in order to use your unit correctly and get the best out of it.
-
Page 5: Table Of Contents
3-2. Mounting the components ........9 Part Names..........11 Names and Functions on the Control Panel ..........12 Using the DC-6 mini, DC-8 mini ....13 6-1. Precautions when Stacking the Papers ..... 13 6-2. Stacking the Paper ..........14 6-3. Procedures ............15 6-4. -
Page 6: Warning
WARNING Use only the power supply voltage displayed. + 6% AC220-240V –10% Voltages Other than 220-240V Prohibited Ensure that the total current of all the units connected to the wall outlet does not exceed power supply capacity. When using the extension cord, ensure that the total current of all the units connected to this extension cord does not exceed the specification of the extension cord. - Page 7 WARNING When not using the product for a long period of time due to vacations, etc., be sure to disconnect the power plug from the outlet. If it malfunctions, fire hazards caused by power leakage may result. Disconnect Plug Remove dusts on the blades of the power plug and the surface from which the blades extend with a dry cloth.
-
Page 8: Precaution
PRECAUTION Do not install the product in environments other than those specified, as this will not only cause the product to rust and malfunction, but will lead to power leakage, fire hazards, and electrical hazards as well. Temperature : 10 ˚C to 35 ˚C Temperature Change Rate : Below 10 ˚C/h Humidity : 20%RH to 85%RH Humidity Change Rate : Below 20%/RH/h... -
Page 9: Installing The Machine
Check whether the following components are present and attach them to the machine. ó ò ô ö õ ú ù û DC-6 mini DC-8 mini Instruction Manual ease et ou e ice p op e ns a l he ma h ne PPPPP PPPPPP @@@@@ @@@@@@ PPPPP PPPPPP PPPPP PPPPPP... -
Page 10: Mounting The Components
3. Installing the Machine 3-2. Mounting the Components Attach the jogger as shown in the fig- ure. Remove the two set screws attached to the main body and fix the jogger unit with the screws. Parts to be used: Jogger unit..1 Jogger Unit •... - Page 11 3. Installing the Machine Attach the auxiliary feed bins. Auxiliary Feed Bin Insert the top end of the auxiliary feed bin into the pillar on the main body. Parts to be used: Auxiliary feed bins..6 (DC-6) Auxiliary feed bins..8 (DC-8) Refer to page 17 for guide A, guide B and the straight stacking guide usage.
-
Page 12: Part Names
4. Part Names Movable Guide Feed Bin Reference Guide Auxiliary Feed Bin Control Panel Slide Plate Jogger (right) Feed Lever Power Switch Paper Receiver Stopper Jogger (left) Paper Receiver Tray Conveyance Cover Connector for Downstream Power Cord... -
Page 13: Names And Functions On The Control Panel
5. Names and Functions on the Control Panel Name Function • When more than two sheets of paper are fed continuously at one time (continuous Feed Bin feed), or when more than two sheets of paper are fed together (multiple feed), the lamp Error (lamps 1 to 8) of the bin where the problem has occurred will light up. -
Page 14: Using The Dc-6 Mini, Dc-8 Mini
6. Using the DC-6 mini, DC-8 mini 6-1. Precautions when Stacking the Papers. ■ Separate sheets of paper before stacking in the feed bin. • If sheets paper are not well separated, it may cause misfeeding or double feeding. • Make folded or curled paper smooth before use. -
Page 15: Stacking The Paper
6. Using the DC-6 mini, DC-8 mini 6-2. Stacking the Paper ■Direction at stacking the paper Depending on the paper size, the stacking direction varies as follows. When using paper between B5 and A3 • Stack the paper lengthways as shown in the figure. -
Page 16: Procedures
6. Using the DC-6 mini, DC-8 mini 6-3. Procedures Insert the power cord into the outlet. Turn the power switch on. • Press the switch in the direction of “I” to turn the power on. • Press the switch in the direction of “O” to turn the power off. - Page 17 6. Using the DC-6 mini, DC-8 mini Select “ON” or “OFF” with the downstream processing switch key. • Select “ON” when using a downstream processing device. • Select “OFF” when the downstream processing device is not used. This switch operation cannot be performed when the downstream processing device is not connected.
- Page 18 6. Using the DC-6 mini, DC-8 mini Determine the paper receiver stopper position. Scale • When using B5, A4, B4 or A3 paper etc., adjust the paper size displayed on the paper receiving stopper to that displayed on the window of the paper receiving plate.
- Page 19 6. Using the DC-6 mini, DC-8 mini 2 Take out a sheet of paper on the feed bin and feed it out along the straight stacking guide up to the paper receiver tray. Jogger (left) 3 Set the jogger (left) to a position with a space of about 5mm from the paper.
- Page 20 6. Using the DC-6 mini, DC-8 mini • When a feed error occurs, correct it. Refer to “On this Occasion” on page 27. • After it is corrected, press the clear key to return the counter display to “0” and press the preset key again.
-
Page 21: Preset Key
6. Using the DC-6 mini, DC-8 mini 6-4. Preset Key The preset key detects which bin contains paper and which does not, and at the same time records the paper size and reference data for multiple feed detection. After this detection, it feeds paper only from the bins containing paper. - Page 22 6. Using the DC-6 mini, DC-8 mini When troubles like mis-feeding, and paper jam occur, check the cause. After checking press the clear key to return the counter display to “0”. Continue to press the clear key until “0” is displayed, the preset key lamp is lit again.
- Page 23 6. Using the DC-6 mini, DC-8 mini ■Turning Off the Multiple Feed Detection Function When the multiple feed detection function is not required, it can be turned off as follows. While pressing the clear key on the control panel, turn ON the power switch.
-
Page 24: On Cluster Stack And Straight Stack Modes
6. Using the DC-6 mini, DC-8 mini 6-5. On Cluster Stack and Straight Stack Modes ■Cluster Stack Mode • The discharged sets are stacked individually by a set on the paper receiver tray as shown in the figure. • Remove the paper discharged last when the machine... -
Page 25: When Using A3, Ld Paper
6. Using the DC-6 mini, DC-8 mini 6-6. When Using A3, LD Paper When using A3 paper, follow the procedure below. 【Sort Mode】 Press the “Paper Receiving Selection Key” and set the “Normal Mode”. Adjust the jogger (left) to the A3, LD mark on the paper scale. - Page 26 6. Using the DC-6 mini, DC-8 mini Move the reference guide to the set Stationary Plate Reference position “A3, LD”. Guide • Lift the upper and lower positions of the reference guide manually and place it in the slot (A3, LD).
- Page 27 6. Using the DC-6 mini, DC-8 mini • Tighten the fixing screw and secure the jogger (right). Jogger (right) Fixing Screw Take out one sheet of the paper on the paper feed tray and place it on the paper receiving plate along the jogger (right).
-
Page 28: On This Occasion
7. On this Occasion 7-1. When the Feed Bin Error Lamp Blinks Cause • This lamp flashes on and off when the paper on the feed bin runs out or when misfeed occurs. Counter measures • Remove sheets of paper discharged to the paper receiver tray because they are not sufficient in volume to make a single collated set. -
Page 29: When The Feed Bin Error Lamp Lights Up
7. On this Occasion 7-2. When the Feed Bin Error Lamp Lights Up Cause Paper • This lamp lights up when two or more continuous sheets of paper at a time are fed into the machine from the same bin with the sheets overlapping 30 to 40mm. Counter measures •... -
Page 30: When The Feed Lever/Paper Receiver Tray Lamp Lights Up
7. On this Occasion 7-3. When the Feed Lever/Paper Receiver Tray Lamp Lights Up Cause The paper tray is full • This lamp lights up when the paper is stacked full on the paper receiver tray. Take out the paper. Counter measures •... -
Page 31: When A Paper Jam Occurs
7. On this Occasion 7-4. When a Paper Jam Occurs 【 When paper jams on the feed ring section】 Lower the feed lever. Feed Lever Pull the jammed paper toward you and remove it. 【When paper jams at the carrier section and reject gate】... - Page 32 7. On this Occasion Remove the jammed paper manually when the jammed paper is not completely discharged as shown in the figure.
-
Page 33: Troubleshooting
8. Trouble shooting 8-1. The Machine Does not Work When the Start Key is Pressed ➡ Set the feed lever to up. 1 Is the feed lever down ? Can operate the machine. ➡ Close the conveyance cover. 2 Is the conveyance cover left open ? Can operate the machine. -
Page 34: Cleaning The Machine And Replacing The Consumables
9. Cleaning The Machine and Replacing the Consumables ■Cleaning the Machine The feed ring and paper separator which function as a paper feeder become smudged with ink and paper shreds as you use the machine. Clean the machine as the smudges may cause feeding problems. - Page 35 9. Cleaning The Machine and Replacing the Consumables When attaching the paper feed shaft, Feed Shaft hold the shaft. When attaching the paper feed shaft, Feed Ring do not hold the paper feed ring. ■Replacing the consumables When the feed ring or the paper separator is worn out, please do not hesitate to request replacing the components at the nearest dealer.
-
Page 36: Specifications
10. Specifications Model DC-8 mini DC-6 mini Desktop vertical type Type 6 bins 8 bins Number of bins Three ring friction method Feed method Conveyance method Roller belt method Bin capacity 20mm (fine quality paper 64g/m or 200 sheets) Minimum...A5 (148x210), Maximum...A3 (297x420), LD (280x432) - Page 37 95Z-90591-97060200S-1...
Need help?
Do you have a question about the DC-6 Mini and is the answer not in the manual?
Questions and answers