Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Flash-e-Vapor V4.5
- Page 1 V4.5/V4.5L Instruction manual english...
- Page 2 IMPORTANT! Please carefully read this instructions manual before using your Flash-e-Vapor V4.5/V4.5L rebuildable atomizer. The Flash-e-Vapor V4.5/V4.5L is a fiber evaporator where the user has to wind his own coils. Both rebuildable atomizers come with a precision ground connecting piece made from borosilicate 3.3 glass. The scope of delivery also includes a connecting piece made from stainless steel and polycarbonate.
- Page 3 Use only liquids (e-Liquids) that are intended exclusively for the use in e-cigarettes. The Flash-e-Vapor V4.5/V4.5L is a rebuildable atomizer, which has been designed exclusively for the use with e-liquids. Before use, it is necessary to wind a coil from suitable resistance wire (e.g.
- Page 4 Flash-e-Vapor V4.5/V4.5L — Instruction english manual Scope of delivery Flash-e-Vapor V4.5/V4.5L 1x socket 1x evaporation chamber (airscrew 1.2 mm mounted) 1x mounted tank with borosilicate 3.3 glass (precision ground) 1x connecting piece polycarbonate (not suitable for liquids containing menthol and triacetin) 1x connecting piece stainless steel 2x airscrews (each 1x 1.4 mm, 2.1 mm)
- Page 5 The socket is tightly screwed in place but should not be put into the ultrasound bath in order to retain its tightness. It is usually sufficient to clean the parts of the Flash-e-Vapor V4.5/V4.5L under warm running water using a brush (e.g. toothbrush) and some detergent.
- Page 6 Flash-e-Vapor V4.5/V4.5L — Instruction english manual Creating and attaching a coil (example) Picture 1: Picture 2: Picture 3: Coil up 6 windings with 0.32 Place the wire as shown Use a wire cutter or any other Kanthal A wire using a winding...
- Page 7 Flash-e-Vapor V4.5/V4.5L — Instruction english manual Cutting and inserting wicks (cotton cord) Wind the socket of your Flash-e-Vapor V4.5/V4.5L. Cut two wicks of approx 10mm from the included cotton cord. Attach the evaporator chamber to the socket. Make sure that the guide pin of the socket is inserted into the groove of the evaporator chamber.
- Page 8 Filling e-liquid For the filling of the tank, the tank has to be turned upside down. Maximum quantities for an empty tank: - Flash-e-Vapor V4.5: 6 ml - Flash-e-Vapor V4.5L: 9 ml Make sure that the liquid is not above max.
- Page 9 Flash-e-Vapor V4.5/V4.5L — Instruction english manual Changing the connecting pieces In order to change the connecting piece, unscrew the air duct from the tank top cap using a 1 cent coin . Remove the tank bottom cap together with the air duct.
- Page 10 Flash-e-Vapor V4.5/V4.5L — Instruction english manual Adjusting the plus pole Some battery mounts may require you to adjust the plus pole to fit the evaporator connection. Use a suitable screwdriver to unscrew or screw in the plus pole screw in the 510 connection with a maximum of 1-2 rotations.
- Page 11 Flash-e-Vapor V4.5/V4.5L — Instruction english manual Artur Schwarze Technical Products Owner S. Schittko www.flash-e-vapor.de...