Table of Contents
Advertisement
5. Plug the adapter into a standard AC
outlet.
6. Press and lift out the handset holder,
flip it over, then snap it back into place.
7. Raise the base's antenna to a vertical
position.
On a Wall
1. Drill two holes 3
apart. Then thread a screw into each
hole, letting the heads extend about
inch (3 mm) from the wall. Ô
2. Plug one end of the supplied long
modular cord into the
on the back of the base.
To connect the phone to two one-line
jack, plug another cord (not supplied)
into the
TEL LINE 2
3. Route the adapter cable and modular
cord(s) through the grooves on the
base.
4. Align the base's keyhole slots with the
mounting screws and slide the base
downward to secure it.
C
ONNECTING
B
P
ATTERY
ACK
The phone comes with a rechargeable
nickel-cadmium battery pack in the handset,
but not connected. Before using your
phone, you must connect the battery pack,
then charge it for about 15–20 hours.
15
/
inches (100 mm)
16
TEL LINE 1/2
jack.
/C
HARGING THE
Ô
To mount the phone directly
on a wall, you need two
screws of at least 1
1
/
8
long (not supplied) with
heads that fit into the
keyhole slots on the bottom
of the base. Follow the
jack
steps under "On a Wall " on
Page 9, then apply these
additional instructions for
placement on a wall.
Ô
NOTE
3
/
inch
8
9
Advertisement
Table of Contents
