Summary of Contents for ElmoTech EMS2000i
-
Page 1: User Manual
ElmoTech Ltd. Version 1.0 STAR UNIT User MANUAL Version 1.0 May 2003 EMS2000i STaR Unit User Manual... - Page 2 Elmo Tech Ltd. NO WARRANTY The technical documentation is being delivered AS-IS, and ElmoTech Ltd. makes no warranty as to its accuracy or use. Any use of the technical documentation or the information contained therein is at risk of the user.
-
Page 3: Table Of Contents
Deactivating the STaR Unit_________________________________ 19 Removing the Transmitter _________________________________ 20 Disconnecting the Transmitter ______________________________ 20 TRANSMITTER CLEANING INSTRUCTIONS __________________ 22 Cleaning the Transmitter: __________________________________ 22 Transmitter strap replacement _________________________________ 23 Reasons for Strap Replacement _____________________________ 23 EMS2000i STaR Unit User Manual... - Page 4 ElmoTech Ltd. Equipment Needed for Strap Replacement ____________________ 24 Replacing the Transmitter Straps ___________________________ 24 FCC Notices________________________________________________ 26 STaR Unit FCC Notices __________________________________ 26 STaR Unit Customer Information ___________________________ 27 Transmitter FCC Notices __________________________________ 27 EMS2000i STaR Unit User Manual...
- Page 5 ElmoTech Ltd. Version 1.0 Table of Figures Figure Page ............8 IGURE DEAL OCATION ................10 IGURE ..14 IGURE ROTRUDING SIDE OF RANSMITTER DIRECTED UPWARDS EMS2000i STaR Unit User Manual...
-
Page 6: The Monitor Center/ Probation Agency
Check that you have all the required equipment: • STaR unit, carrying pouch and power adapter • Transmitter • Home Unit • Electronic key • Locking device • Strap holder • Strap clips (male and female) EMS2000i STaR Unit User Manual... - Page 7 Screwdriver (to open a clip if necessary). It is recommended to use a 5 mm flat head screwdriver. It is always advisable to bring an extra set of strap clips to cater for the event in which the first set may be accidentally damaged during the installation. EMS2000i STaR Unit User Manual...
-
Page 8: The Offender's Premises
3 feet off the ground and at least 1 foot away from the wall. Figure 1 Ideal Home Unit Location The Home Unit should be placed in an open area away from other electrical appliances, personal computers, laptops or metal objects. EMS2000i STaR Unit User Manual... -
Page 9: Activating The Star Unit
LCD. At this stage the unit runs through an initial series of Built-In-Tests (BIT). After completing the tests the LCD will display the default STaR message, indicating that the STaR unit is in a working state. EMS2000i STaR Unit User Manual... - Page 10 LED’s flash for 10 seconds, it could indicate one of the following possible failures: ● Case open micro-switch malfunction ● Range threshold values lost (maximum reception range is used in this case). EMS2000i STaR Unit User Manual...
-
Page 11: Downloading The Curfew Schedule And Default Offender Parameters11
If the download is successful, the following information is downloaded: • Transmitter code • The curfew schedule • Hot zones (inclusion / exclusion) • Left violation sensitivity EMS2000i STaR Unit User Manual... -
Page 12: Installing The Transmitter
. Press the Electronic Key down over one pair of metal pins (it does not matter which) with the two touch points on the Electronic Key EMS2000i STaR Unit User Manual... -
Page 13: Attaching The Transmitter
In order to attach the Transmitter to the Offender, do the following: Flip a strap holder over the short strap of the Transmitter. Attach the female Clip to the underside of the Transmitter’s short strap (to lie against the Offenders skin). Verify that the closed end EMS2000i STaR Unit User Manual... - Page 14 Transmitter over the sock before it is fastened. Cover the female Clip with the male Clip ensuring that the four pins on the male Clip fit correctly into the female Clip (the markings on the side of each clip have to match). EMS2000i STaR Unit User Manual...
-
Page 15: Star Unit Range Setting
Once the range setting test has been initiated by the Monitor Center, the following occurs: • The Offender’s telephone rings approximately 2-3 times. EMS2000i STaR Unit User Manual... - Page 16 An assistant stands next to the STaR unit and observes the left LED indicator. Every time the STaR unit receives a transmission from the PID (approximately every 20 seconds) the left LED flashes 3 times in quick sequence. EMS2000i STaR Unit User Manual...
- Page 17 STaR unit automatically terminates the range test 15 minutes after initiation. Therefore, if the range test lasts longer than 15 minutes, you will have to make a request to the Monitor Center / Agency to re-activate it. EMS2000i STaR Unit User Manual...
-
Page 18: General Rules For The Offender
• Disconnect any of the cords from the back of the Home Unit • Open the Home Unit • Move out of the designated safe area • Open Transmitter strap • Cut the Transmitter strap EMS2000i STaR Unit User Manual... -
Page 19: Removing The Monitoring System
Pack the power-cord plus adapter in the original box. For practical reasons please note to place the accessories in the original box. The STaR unit’s serial number will be written on the front side of the box. Carry the monitoring unit in its original packaging. EMS2000i STaR Unit User Manual... -
Page 20: Removing The Transmitter
Press the Electronic Key down over one pair of metal pins (it does not matter which) with the two touch points on the Electronic Key EMS2000i STaR Unit User Manual... - Page 21 (2) seconds on. If the Electronic Key battery is low the red light will immediately flash for two (2) seconds, once the red button is pressed. (No command is sent to the Transmitter). EMS2000i STaR Unit User Manual...
-
Page 22: Transmitter Cleaning Instructions
Using a soft brush or another piece of cloth/towel gently scrub the inner side of the Transmitter along the "tracks". Wash the Transmitter in clear water. Dry the Transmitter using a piece of cloth/paper towel or simply let it drip dry. EMS2000i STaR Unit User Manual... -
Page 23: Transmitter Strap Replacement
Many times, only one side of the strap is damaged. If this is the case, you may want to leave the undamaged side in place and replace only the damaged side of the strap. EMS2000i STaR Unit User Manual... -
Page 24: Equipment Needed For Strap Replacement
Gently place the strap down over the metal pins and press down along the seam of the strap, snugly fitting the entire strap to the Transmitter. Put the strap clasp back in place (the wider side pointing in- wards). EMS2000i STaR Unit User Manual... - Page 25 1-3 and make sure that the strap is positioned correctly over the pins. Then repeat steps 5-6 and perform another reset. If changing one side of the strap does not work, you should try and change the other strap side according to steps 1-7. EMS2000i STaR Unit User Manual...
-
Page 26: Fcc Notices
• Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment. EMS2000i STaR Unit User Manual... -
Page 27: Star Unit Customer Information
The TXMTR Model 500 complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. EMS2000i STaR Unit User Manual... - Page 28 Increase the separation between the equipment and the receiver. • Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment. EMS2000i STaR Unit User Manual...
Need help?
Do you have a question about the EMS2000i and is the answer not in the manual?
Questions and answers