Advertisement
Quick Links
Advertisement
Summary of Contents for BUDDEE SP-A-PH
- Page 1 USER MANUAL Model : SP-A-PH...
- Page 2 Buddee Smart Plug - User Instructions – SP-A-PH Connecting the Smartplug 1) Remove the smartplug from its packaging. 2) Disconnect your Window Type AC unit from the wall power socket. 3) Plug the smart plug into the wall power socket, being careful to align the prongs of the plug with the wall socket correctly.
- Page 3 Buddee Smart Plug - User Instructions – SP-A-PH Installing the mobile application 1) Locate the QR codes on the inside of the top lid of the packaging for your smart plug. There are two QR symbols, one for iOS and one for Android.
-
Page 4: Led Status
Buddee Smart Plug - User Instructions – SP-A-PH LED Status Your Buddee smart plug has two LED’s located on the top of the plug, one is RED and the other is GREEN. Each LED will either be OFF, STEADY, or FLASHING, to indicate an event. -
Page 5: Troubleshooting
Please refer to our detailed troubleshooting guide at www.buddee.ph/troubleshooting Contact Us If you have any issues or need assistance in setting up your Buddee smart plug or the mobile application, you can contact our customer service through these channels: Monday to Sunday, 9am – 9pm Email: support@cortex.ph... - Page 6 Buddee Smart Plug - User Instructions – SP-A-PH Federal Communications Commission (FCC) Statement Labelling requirement for small device statement (FCC15.19(3)) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 7 Positioning for disconnection: The socket outlet shall be installed near the equipment and shall be easily accessible. To disconnect, pull device from outlet To avoid any risk or hazard that may be caused due to the end product connected to Buddee, please read and understand the operation of the connected equipment before operating with Buddee ...