Advertisement
SET UP
Plug the handset cord into the jacks on the handset and
base.
Plug one end of the supplied long telephone cord into the
jack on the back of the base. Plug the other end into a
modular phone jack.
Attach the mounting bracket as shown.
If you mount the phone on the wall, press up on the hand-
set cradle hook to remove it. Then turn it over so its
tabbed edge faces up, and press it back down into its slot.
Note: The phone company charges to install any neces-
sary jacks. The USOC number of the jack to be installed
is RJ11C (or RJ11W for a wall mount).
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol is intended to alert you
that parts inside the telephone present
a risk of electric shock. Do not open
the case.
This symbol is intended to alert you to
important
operating
instructions included in the papers with
the telephone.
USING THE PHONE
Press the switchhook to
disconnect a call.
Handset Cradle Hook
Set the switch to
or
to adjust the handset
HI
volume to a comfortable
listening level.
Press
REDIAL
number dialed (up to 32 digits).
STORING/DIALING NUMBERS IN MEMORY
To store a number into memory:
1. Lift the handset (or press
press
2. Enter the telephone number you want to store (up to
16 digits).
3. Press
memory location, then return the handset to the cra-
dle (or press
and
servicing
Use this holder to hold the handset
temporarily without disconnecting
a call.
,
,
LO
MED
to dial the last
Press
to temporarily switch
to tone dialing when using pulse
service.
SPEAKERPHONE
STORE
.
,
, or
to store the number into that
P1
P2
P3
SPEAKERPHONE
) .
RadioShack is a registered trademark used by Tandy Corporation.
Press
STORE
number you want to store. See "Storing/
Dialing Numbers in Memory."
To dial a number in memory:
) and
1. Lift the handset (or press
2. Press
,
, or
.
P1
P2
P3
Note: If you store an emergency service's number (po-
lice, fire department, ambulance) and you want to test
the stored number, make the test call during the late
evening or early morning hours to avoid peak demand
periods. Remain on the line to explain the reason for
your call.
ÐÐ
1997 Tandy Corporation.
All Rights Reserved.
once to enter the phone
Switch to
or
to
TONE
PULSE
match the type of service you
have.
Set the ringer switch to
in a
HI
noisy room or
in a quiet
LO
room. To turn off the ringer, set
it to
OFF
. You can still make
calls with the ringer off and you
can also receive calls if you
hear another phone on the
same line ring.
Slide
to adjust the
VOLUME
speakerphone
volume to
a
comfortable listening level.
Lights when you are using the
speakerphone.
Press to activate the
speakerphone for hands-
free conversation or on-
hook dialing.
).
SPEAKERPHONE
Advertisement
