Subscribe to Our Youtube Channel
Related Manuals for Power Master ASW
Summary of Contents for Power Master ASW
- Page 1 INSTALLATION AND OWNER’S MANUAL MODEL ASW Actuator Swing Gate Operator PM CONTROL BOARD INSTRUCTIONS INCLUDED Serial #: Date Installed: READ THIS MANUAL CAREFULLY Your Dealer: BEFORE INSTALLATION OR USE. SAVE THESE INSTRUCTIONS.
- Page 3 IMPORTANT NOTICE FOR GATE OPERATORS MANUFACTURED AFTER JANUARY 11, 2016 All gate operators manufactured after January 11 , 2016 must have a monitored input for each direction. In order to satisfy this requirement all Powermaster Swing & Slide Gate Operators will have one monitored input for each direction: The close obstruction (C-OBS) terminal for the close direction and the open obstruction (O-OBS) terminal for the open direction.
- Page 5 Calculate the height of the system from the ground to the adaptor cover by means of screws V. (It is advisable to define a position as centered as possible with respect to the main gate and in 2. Carry out the wiring by referring to the wire correspondence with a strong cross girder). Weld the diagram shown in Figure 5. plate P following measures in Figure 1. 3. It is mandatory to provide for ground by using With the gate closed, weld bracket S to a cross the GND Terminal. beam of the main gate or other element with equal strength, according to measures shown in Figure 1. Keep in mind that when carrying out this operation, TECHNICAL DATA FOR POWERMASTER ASW the actuator should not be totally in a stroke end Power Supply 24VDC position. Absorbed Rating 120W Remove cover C by loosening screw F. Then fix the Absorbed Current 6.7A actuator to plate P by means of screw T and nut D Thrust 494.5 LBF (Figure 2). Lock the actuator to plate S by means of Jogging Intensive screw V and washer R.
- Page 12 ASW END USER GUIDE Safety Rules Maintenance • Do not stand in the movement area of the door. • Every month, check the good operation of the emergency manual release. • Do not let children play with controls and near the door. • It is mandatory not to carry out extraordinary maintenance or repairs as accidents may be • Should operating faults occur, do not attempt to caused. These operations must be carried out by repair the fault, but call a qualified technician. qualified personnel only. • The operator is maintenance free, but it Manual and Emergency Operation is necessary to check periodically if the In the event of power failure or fault, manually safety devices and the other components of open and close the door/gate with the following automation system work properly. Wear and tear procedure: of some components could cause dangers. 1. Open the protection door of the release device (Figure A). Waste Disposal 2.
-
Page 14: Supplementary Instructions
SUPPLEMENTARY INSTRUCTIONS FOR UNITS EQUIPPED WITH THE PowerMaster Controller... - Page 26 DUAL GATE INSTALLATIONS: XXXXXXXXXXXX...
-
Page 29: Registration Information
Register your Product link. You can also send via fax (631-231-4274) or via email to pmtech@optonline.net. If registration is not activated, a one-year warranty will apply. REGISTRATION INFORMATION Operator Information Location Installed Model ASW Address Serial # Address Date Installed Address Installer’s Information... - Page 30 Notes...
- Page 31 Notes...
- Page 32 Need Technical Support? Visit: www.vepower.net/faqs Call us toll free @ 1-800-243-4476 Email us: PMtech@VEpower.net www.facebook.com/PowerMasterOperators...
Need help?
Do you have a question about the ASW and is the answer not in the manual?
Questions and answers