Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Foldaway F1-230 V10
-
Page 1: Cover
V 1.5 Model F1-230 V10 European version www.foldaway.at BEB.203.214.9 Document Number Before first use of the appliance please read these Operating Instructions and act in accordance with them. ... -
Page 2: Declaration Of Incorporation In Accordance With Eu Machinery Directive 2006/42/Ec Ii, 1B
Declaration of incorporation in accordance with EU Machinery Directive 2006/42/EC Annex II, 1B The Manufacturer: The Product: foldaway automatic spa cover lift BEB Fertigungscenter GmbH & Co KG model F1-230 Bäckerstrasse 1 model F1-120 2433 Margarethen am Moos Austria We hereby declare that the mentioned product with adjacent serial number is intended for incorporation in other machinery and comply with all provisions of the EU Machinery Directive 2006/42/EC. -
Page 3: Illustrations
Illustration A Illustration B... -
Page 4: Emergency Lift Operation
Illustration C Illustration D EMERGENCY LIFT OPERATION 1. REMOVE THE PLASTIC SECURING CLIP FROM THE COVER DOWEL ON BOTH SIDES 2. DETACH THE LIFT CARRIAGE MECHANISM FROM THE COVER ON BOTH SIDES 3. MANIPULATE AND SECURE THE COVER MANUALLY ... -
Page 5: Table Of Contents
Content Cover Declaration of incorporation in accordance with EU Machinery Directive 2006/42/EC II, 1B Illustrations Emergency lift operation General Information Disclaimer Proper Use Environmental Protection Warranty Symbols in this manual Safety Instructions Lift Overview System description Safety Devices Smart key docking system Cover quick release mechanism Self locking drives Overload protection... -
Page 6: General Information
Dear valued Customer, please read and comply with these instructions prior to the initial operation of your foldaway spa cover lift and store them for later use. BEB Fertigungscenter GmbH & Co KG (BEB) has prepared this manual for instructed personnel only. -
Page 7: Proper Use
BEB is not responsible for water logged or overweight covers and assumes no responsibility for system failure due to water logged or obstructed covers. The foldaway lift system may not function properly with 3rd party covers exceeding the designed total weight and/or incompatible structures. Contact your local dealer for a suitable spa cover. -
Page 8: Safety Instructions
Safety Instructions The lift may only be connected to alternating current and must be installed in accordance with IEC 60364. Installation of the lift system shall only be carried out by a certified and trained dealer. The voltage must correspond with the type plate on the control box. Never engage the lift when persons or animals are in the spa or in the lift movement area. -
Page 9: Lift Overview
(optional) System description The foldaway lift controller is designed for driving two self locking 24V DC actuators in parallel by applying pulse width modulated signals (PWM) at a frequency of 16kHz. This high frequency gives the systems it´s high efficiency, low noise and low power stage loss. -
Page 10: Safety Devices
Lock The smart key is magnetically coded and key to any lift operation. When pulled the foldaway lift system is locked and the safety controller will ignore any attempt of lift engagement. A white orientation light will illuminate the docking area during night. -
Page 11: Safety Controller
Danger areas The foldaway lift system is able to detect certain objects in areas with a potential risk of injury. Depending on programmed parameters the lift setup can be less sensitive to small objects e.g. -
Page 12: Daily Operation
Rotate the smart key one detent clock wise to open the spa cover or Press the open symbol on the optional infrared (IR) remote control or Touch the open symbol on the remote control screen of your foldaway smartphone app. -
Page 13: Manual Stop
Upon reaching the programmed end position in open direction, the lift stops with a time ramp in order to prevent cover teeter. The foldaway lift system moves the cover within approx. 30 sec into the programmed end position. While the motors run the illumination of the dock changes to yellow. The foldaway controller... -
Page 14: Maintenance
Maintenance Inspect your cover periodically. Do not use a suspect cover system. Perform a visual check periodically, specially of the cover carriage mechanism. The front cover should be slightly tilted towards the spa front as soon as the back cover comes to full rest. -
Page 15: Troubleshooting
On board diagnose system (status LED on pcb) In addition to the diagnose routine in the foldaway app the qualified technician has a hardware diagnose system implemented in the foldaway controller circuit board: If the smart key panel illuminates continuous blue, the on-board diagnose system allows a more detailed identification of the occurred fault: # flashes... -
Page 16: Manual Lift Alignment
Manual alignment Under normal conditions there is no need to manual align the system. Autohome eliminates minor synchronization errors and deviations in position sensor data during each closing. However - a manual alignment can be initiated by turning the smart key clockwise approx. 180 degrees (3 short beep) and back within 2 seconds to the original position. -
Page 17: Questions & Answers
What is wrong when,…. Q: My lift stops when closing the spa as soon as the rear cover settles down ? A: The stop nut in the carriage mechanism is not adjusted correctly. The controller misinterprets the wrong tilted front cover as an obstacle since the cover does not move down freely. Use an allen key to adjust the stop nut inside the carbon support: The setup is correct when the forward cover, when laterally viewed is a few degrees tilted towards the front spa panel when the back cover rests flat on the spa shell. - Page 18 QR card on page 28, alignment required section ________________________________________________________________________ Q: My foldaway lifts the mid section of the cover before the front cover raises. A: The front cover sticks to the spa shell e.g. after a longer period of not using the spa or in cold environment when moisture between the cover and the spa freezes.
-
Page 19: Technical Specification
Technical Specification actuator voltage: 24V DC main power: 230V AC (EU) or 120V AC (US), 50/60Hz, 150VA internal fuse 6,3A (20x5) power stage max temp.: 120°C drive modulation and frequency: PWM, 16kHz ultra low noise ambient temp.: Ta -20°C bis +60°C standby power: 15mA ... -
Page 20: Contact Information
BEB Fertigungscenter GmbH & Co KG Bäckerstraße 1 2433 Margarethen am Moos Austria Phone +43 2230 20 270 130 Fax +43 2230 20 270 900 email support@foldaway.at ... -
Page 21: Quick Reference Card
QUICK REFERENCE CARD normal operation white orientation light, lift standby mode locked OPEN CLOSE green ready yellow STOP with command or remove smart key motors running yellow/blue blinking cover heavy or clean cover cover lifetime monitor impaired by object replace cover user action required 180°...