DTC TAC COM 2005 User Manual

8 channel rx & tx tactical repeater

Advertisement

Quick Links

TAC COM 2005
User Programmable
8 Channel RX & TX
Tactical Repeater
NTIA Compliant
DTC COMMUNICATIONS, INCORPORATED

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TAC COM 2005 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for DTC TAC COM 2005

  • Page 1 TAC COM 2005 User Programmable 8 Channel RX & TX Tactical Repeater NTIA Compliant DTC COMMUNICATIONS, INCORPORATED...
  • Page 2 Website: www.dtccom.com The information in the document is subject Email: info@dtccom.com FCC information to change without notice. DTC makes no representations or warranties with respect to The following information is provided as a the contents hereof, and specifically disclaims 486 Amherst Street...
  • Page 3: Table Of Contents

    WARNING: In order to comply with FCC rule 47 CFR 1.1310 regarding general population radiation exposure, deployment of this device must be such that unaware bystanders maintain a minimum separation from the antenna of 42 cm. DTC COMMUNICATIONS, INC.
  • Page 4: Quick Start

    QUICK START Complete the following steps to start using your TAC COM 2005: 1 1 1 1 1 Set Receiver Channel to match your body wire transmitter frequency. 2 2 2 2 2 1 1 1 1 1 2 2 2 2 2...
  • Page 5: Description

    It does this by receiving a weak signal on one channel and retransmitting the signal (at the same time) on a second channel, at higher power. The TAC COM 2005 has special features that extend its capabilities for surveillance operations. These include a phono output for direct...
  • Page 6 DESCRIPTION The TAC COM 2005 is a portable 2 Watt VHF FM tactical repeater capable of receiving and transmitting both 12.5 kHz and standard wideband (+25 kHz signals). Both the receive and transmit frequencies are user-programmable within a 2 MHz range and can be set to any of eight switch selected channels for both RX and TX.
  • Page 7: Operation

    DC If the transmit condition source such as automotive power. The performance of the TAC COM 2005 stops, you may be receiving a is highly dependent on the proper location and third-party transmission on orientation of the antenna.
  • Page 8: Components

    Optional Scrambling SCRAMBLE ON/OFF SWITCH - If your TAC COM 2005 is equipped with the optional Scrambler feature, a Scramble ON/OFF switch is located on the main panel. Generally, it is recommended that you test the system first with the Scramble feature turned OFF.
  • Page 9 Adjustment is not usually needed. If needed, make sure the bodywire transmitter is OFF. Loosen the locknut and use a small screwdriver to turn the Squelch control on the TAC COM 2005 counterclockwise until the Master Power LED turns RED. Then turn the adjustment slightly clockwise until the LED turns GREEN.
  • Page 10: Troubleshooting

    Ensure that body wire transmit frequency and TAC COM 2005 receive frequency are the same. Ensure that the body wire transmitter is in range of repeater. Ensure that the TAC COM 2005 antenna is positioned vertically, or an external antenna is in use. Ensure that an antenna is attached to the antenna jack.
  • Page 11: Troubleshooting

    • The TAC COM 2005 can be powered with an AC to DC converter, • Put the TAC COM 2005 on the smart charger until the LED on the or an automotive accessory power cord. If the internal battery is...
  • Page 12: Specifications

    RCA Female, line level Display Volt Meter 4 to 25 VDC Charging, Charged External (AC Power Smart Charger) 4 to 6 hours charge time Optional Features Scrambling Single Inversion (Optional) Hot Mic Connection Hot Mic optional User Programming Optional DTC COMMUNICATIONS, INC.
  • Page 13: Accessories

    ACCESSORIES Hot Microphone The TAC COM 2005 may be turned into a continuous 2 Watt Transmitter Mag-Mount Antenna by attaching the DTC Hot Mic. ANT-3 Cellular look-alike mobile antenna with magnetic When attached via the 15 pin base and BNC connector.
  • Page 14: Warranty

    The warranty shall not apply to Engineering Prototypes or Customer requested modifications to electronic circuits. This warranty does not apply to and DTC does not independently warrant items or systems sold by DTC which are produced by other manufacturers. With respect to such items, the Customer shall look to the warranty of the original manufacturer and DTC disclaims all warranty, expressed or implied.
  • Page 15: Contact Us

    (603) 546-2217 voice (727) 392-4761 WA, OR, ID, MT, ND, WY, SD fax (603) 880-6965 fax (727) 320-0509 glang46@aol.com NH, VT, ME, TX, OK, AR, LA FL, GA, AL, MS, TN, NC, SC, VA cguzman@dtccom.com fprioli@dtccom.com DTC COMMUNICATIONS, INC.
  • Page 16 486 Amherst Street • Nashua, New Hampshire 03063 • 603-880- 4411 www.dtccom.com...

Table of Contents