Advertisement
-Press "Talk" key to get the headset, the "In use" LED is ON.
During a talk conversation, you can adjust the talk volume (1 ~ 5 levels) by simply pressing • or ‚ key.
End a call
-Press "Talk" key, the "In use" LED is OFF.
Mute
-During a call conversation, you can mute your voice by pressing "Mute/CH" key, the headset will show
mutetone that you can talk freely without be heard by the talk party, and you still be able to hear the talk party.
-Deactivate the mute function, press "Mute/CH" again.
Headset Power On / Off
To power Off the headset
- Press and hold "Talk" key about 3 seconds, the headset will switch off which can prolong the use time of
headset.
To power On the headset
-Press "Talk" key
The headset will power on with the "In use" LED light about 10 seconds, then the headset will return to the
standby mode.
Out of range indication
If your headset has registered and is in located range, the "In use" LED will blanking steadily, when your
headset goes out of range, the communication link will be lose temporarily, the "In use" LED will blink.
If you go back to the located range again, the communication link will restore, also the "In use" LED will
blanking steadily.
Note: your talk will be cut without any audible warning tone if you are in a talk and out of the located range.
Registration
The headset and base shall be factory pre-registered with the identification digital security codes, which are
stored into the non-volatile memory, so that your headset shall be ready for working after out-of-box. However,
your headset shall also has a procedure to allow you to re-do the registration operation in case of the link is lost
accidentally.
-press ‚ key 3 times, Press and hold • key for 3 seconds on the headset "In use" LED is ON, your headset
entered the registration mode
-Press and hold SUB key for 3 seconds on the base until "SUB" LED is ON, the base also entered the
registration mode.
Note: SUB key A1-A4 is for channel A station, B1-B4 is for channel B station.
-About 5-10 seconds the headset "In use" LED is OFF that means the headset has located the base, and the base
until "SUB" LED is OFF too.
-If the headset does not locate the base, the headset "In use" LED will be blink after 15 seconds and it will
return to the non-located mode. Try again and check that you are not in the interference environment
Note: your base can register up to
headsets. One headset register on the every subscribe key.
eight
Unsubscribe headset registered
-At standby mode
-Press and hold SUB key enter the base's registration mode with the "SUB" LED is ON
Page 3
Advertisement
