Aerohive AH-APPLIANCE-1 User Manual

Open topic with navigation
You are here: Reference Material > Hardware Reference > VPN Gateway > VPN Gateway
HiveManager 6.1r5 Enterprise Mode Help System.
The Aerohive VPN Gateway Appliance User
Guide
Compliance Information: For compliance information for these devices, see
and-online-training.
The Aerohive VPN Gateway appliance (model AH-VG-1U, AH-APPLIANCE-1) provides on-site management and termination for
up to 4000 Layer 2 GRE and Layer 3 IPsec VPN tunnels. The appliance ships with 4 GB of memory, which can be expanded to
up to 16 GB, and provides a WAN Ethernet port and a LAN Ethernet port, two USB 2.0 ports, and an RJ45 Console port.
For more information about Aerohive Hive Manager appliances in general, see
Appliances"

Safety Guidelines and Regulatory Compliance Statements

The cautions, warnings, and compliance information in this section apply to the VPN Gateway appliance (AH-VG-
1U/AH-APPLIANCE-1).
Follow the safety guidelines below to ensure the safety of personnel and equipment. The following safety icons are
used in these guidelines to identify the type of precaution:
This icon indicates a general caution. Failure to comply with a caution notification can result in
damage to equipment.
This icon indicates an electrical caution. Failure to comply with an electrical notification can result
in serious injury or death, and extensive damage to equipment.
This icon indicates a laser caution. Failure to comply with a laser caution can result in serious
injury.
Do not install the device in an environment where the operating ambient temperature might exceed
the recommended ranges.
The following table lists the safety precautions you should follow when installing your VPN Gateway appliance.
Electrical equipment generates heat. Ambient air temperature may not be adequate to cool
equipment to acceptable operating temperatures without adequate circulation. Be sure that the
room where you install your device has adequate air circulation.
Changes or modifications made to this device that are not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry. ESD damage
occurs when electronic components are improperly handled and can result in complete or
intermittent failures. Be sure to follow ESD-prevention procedures when
Make sure the rack or cabinet housing the device is adequately secured to prevent it from becoming
unstable or falling over.
Disconnect all power by turning off the power switch and unplugging the power cord before
installing or removing a device, or working near power supplies.
http://www.aerohive.com/support/tech-docs-
"Aerohive HiveManager and VPN Gateway
Página 1 de 4