Advertisement
Table of Contents
Advertisement
Table of Contents
Summary of Contents for AlienBuffalo AB-2000
- Page 1 THE BUFFALO TENT MINI Model AB-2000 OWNER’S MANUAL...
- Page 2 SAFETY CARE WARNING: Keep all flame and heat sources away from this tent. this Always store your tent clean and free of debris, to avoid mildew tent meets the flammability requirements of CPAI-84. This tent is forming, never store your tent damp, mildew damage is not covered made with flame resistant fabric.
- Page 3 PARTS To order replacement parts email us at support@alienbuffalo.com DESCRIPTION PART NUMBER C1006 Eye bolt H1010 Washer H1005 Rubber washer H1003 Hex Nut H1004 Clamp H1006 Hub quick release pin Section 1 Leg assembly A1001 Top cap C1005 pole section 1...
- Page 4 SETUP INSTRUCTIONS Remove tent from bag. Place upright. Open the clamp lever (A). Extend out section 2 of each leg (B). The section is fully extended Pull all 5 legs fully away from the center. Repeat step 4 on every leg, one section at when you see the pin hole.
- Page 5 Stake both corner loops into the ground. wall section between is tightened. For online guides, videos, questions, and support please visit www.alienbuffalo.com/support Work around the tent repeating steps It’s time to enjoy your Buffalo Tent! 6 & 7 until the tent setup is complete.
- Page 6 TAKEDOWN Remove stakes Collapse section 3 of every leg • Open clamp lever • Collapse section 3 into section 2 • Close clamp lever • Repeat on all 5 legs Clamp Collapse section 2 of every leg Section 1 • Open clamp lever •...
-
Page 7: Troubleshooting
TROUBLESHOOTING Problem Solution 1) Condensation This is caused by lower temperatures on the outside of the tent combined with body heat on the inside of the tent. When this occurs avoid touching walls to reduce contact leakage. Leaving the door and windows open will reduce condensation of moisture. - Page 8 +1.530.322.0123 REV. C...
Need help?
Do you have a question about the AB-2000 and is the answer not in the manual?
Questions and answers