Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Taege RC350
- Page 1 RC350 Controller Rev 01.05 Manufactured by: Dealer / Local Agent Taege Engineering Ltd Main West Road, Sheffield 7500 New Zealand Ph: 64 3 318 3824 Fax: 64 3 318 3646 E-mail: sales@taege.com www.taege.com 07/11/2016 A Ground Breaking Company Since 1923...
-
Page 2: Table Of Contents
Contents Page Introduction Starting the Controller Quick Calibration Calibration Check Operating the Controller Additional Tasks Controller Configuration Glossary Warning Screens Disclaimer Warning 07/11/2016 A Ground Breaking Company Since 1923... -
Page 3: Introduction
New Zealand farmers and contractors. Taege Engineering want you to be satisfied with your product, which has been designed and manufactured to provide years of dependable use. -
Page 4: Starting The Controller
Starting the Controller Always connect all the cables to the machine. When the RC 350 Controller is powered up it always starts in the “Stopped” mode. At the top of the screen you will see "Front", a "clock" and “>" & "," buttons. If you touch the ">"... -
Page 5: Quick Calibration
Quick Calibration Plug in the RC350 Controller and make sure that the power supply to the machine is connected. 1. Choose the hopper you wish to calibrate by using "<" or ">". 2. Move the collector tray and place the calibration tray under the sponge rollers and press "Prime"... -
Page 6: Calibration Check
Calibration Check 1. At anytime you can test the calibration setting by using the following method. 2. Choose the hopper and crop to be tested. 3. Lift the wheel or jockey wheel into a free running position. 4. Then on the controller screen press "Menu"... -
Page 7: Operating The Controller
Operating the Controller “GO” mode. “GO” When the green is selected the controller goes to the "Area" screen and the button “STOP” changes immediately to a red button. All screens in the "GO" mode have "Running" on the screen to alert the operator that the machine is operating. The “Area”... -
Page 8: Additional Tasks
Additional Tasks “Menu” takes you to screens that enable you to configure and diagnose the machine's settings. “Empty” takes you to the “Run Hopper to Empty” screen in the off mode. This screen allows the operator to nominate the “rpm” and “seconds” for the "Run Hopper to Empty"... -
Page 9: Controller Configuration
“Drill” button takes the operator to the “Drill Settings” screen. This screen is only active in the “Stopped” mode and should only be altered when the operator is changing from one machine to another and in contact with either their Taege Dealer or Taege Engineering Ltd technical person. -
Page 10: Glossary
Glossary Button Name Button Function Puts the machine into the operating mode STOP Stops the machine operating Running The machine is operating kg/ha Kilograms per hectare Select Crop The crop selected in the crop list for that hopper Menu More functions available Prime Primes the selected hopper Calibrate... -
Page 11: Warning Screens
Additional Configuration Additional configuration settings are available when the RC350 Controller is replaced or moved to another application and should only be accessed when a Dealer or Taege technical person has been contacted. Disclaimer The information in these instruction sheets may or may not apply to your controller.