Advertisement
Specifications
Lift
Range
Min.15-3/4"
Max. 28-1/8"
Failure to follow these warnings could cause a loss of load, damage to equipment, and/or failure of
equipment, which may result in personal injury or property damage.
This jack is designed to remove or install only automotive or truck transmissions.
Using the jack in a manner for which it is not designed may result in injury or
damage to equipment.
The load must not exceed the maximum rated capacity of 1 ton.
Stay out from underneath the load at all times.
Secure the load to the jack.
Use the jack on hard, level surfaces only.
Lower the load completely before moving the jack.
This is a lifting device only.
Always wear safety glasses when using this equipment.
Center load on saddle before lifting.
Never work on, under or around load until it is properly supported.
Do not use this product for any other purpose other than that for which it was
intended.
Caution
Read, study and understand the operating instructions before use. You must never overload the jack and
use on level surfaces. Make sure the release valve never gets adjusted.
Description
This jack has a low enough profile to raise forklifts and a high enough profile to raise farm equipment,
tractors, and some earth moving equipment.
Operation
To raise the load:
1.Put the handle into the handle socket, and then tighten the handle screw.
2.Close the release valve tightly (by turning clockwise). Do not over-tighten.
3.Position jack under load so that the arm lifting point will contact load firmly and the load is centered so it
cannot slip.
4.Operate jack handle until arm- lifting point approaches the load. Once again check to see that arm lifting
point is correctly positioned.
5.Raise load to desired height.
To Lower Load:
1.Open release valve very slowly (by turning the handle counter clockwise).
2.When release valve is opened, the arm- lifting point will be lowered.
Overall
Length
26-1/2"
Saddle
Min.2-1/2"
Max.18"
Net
Weight
92 lbs
Advertisement
