Advertisement
11.
Loosen the screws in the top retaining brackets.
Rotate the brackets from shippiong position to the in-
stall position. Retighten. See
Figure 70.
FIGURE 70
NOTE: Position
"A''-Compactor
frame will be flush with
cabinets.
Remove
cabinet
mount
screws
from retaining
brackets. Save for use in step
13.
Position '73"-Midpoint
between position 'IA" and "C."
Position "C"-Drawer
front will be flush
with
cabinets.
12.
When moving or lifting the compactor, use a glove to
protect and cushion your hand.
To prevent damage to floor covering, do not allow the
rear frame of the compactor to touch the floor when
lifting or rolling. (See
Figure 77.)
/j
'I
1
I
1-l
,-II
FIGURE
11
Align the rear of the compactor with the cabinet
opening.
Plug the power cord into a properly
grounded receptacle. See
Figures
7 and 2
Lift the front of the compactor and roll into the opening
until the retaining backets stop the unit.
13.
Fasten the retaining brackets to the underside of
the counter top with the screws provided. Use
auxiliary clip for fastening to cabinet front when
counter top mounting method is not permissible. See
Figure 14.
RETAINER BRACKET
RETAINER BRACKET
COUNTER TOP MOUNTING
Al TERNATE CABINET FRONT
HGURE 72
MOUNTING
Lift the front of the compactor until it is parellel with
the cabinet front. Place a screwdriver or other wedge
under the front edge of the compactor.
14.
Loosen the screws to the front levelers (do not remove
screws). Pivot the levelers to the floor and retighten
screws.
See Figure
13.
FIGURE 13
15.
Replace the drawer.
ADJUSTABLE
TOE PLATE
In some installations,
the toe plate may rub the floor
covering. If this occurs, the toe plate clearance may be
changed as follows:
1.
Determine the amount of interference of the toe plate
with the floor covering.
2.
Remove the drawer from the unit. (Refer to Step 3 of
the Installation Instructions.)
3.
Lay drawer so the front panel faces upward. Protect the
floor.
4.
With a ruler and a pencil or chalk, draw a line where
the toe plate interferes with the floor covering.
5.
Use a pair of scissors and cut toe plate along this line.
See Figure 14.
6.
Replace drawer in unit.
FIGURE 14
CHANGING
FRONT PANEL COLOR
During installation, or in the future, you may wish to change
the front panel color. Your compactor has an extra panel,
which offers four color options. See detail of assembly in
Figure 75.
2 SPACERS
2 TWO SIDED
COLOR PANELS
DRAWER
TRIM
Advertisement
