Advertisement
Quick Links
X30 SERIES
QUICK START GUIDE
This guide is applicable for X32, X32e and X33
Published Oct 2016, Rev 0.4
P2 WIRELESS TECHNOLOGIES
Copyright © 2016. P2 Wireless Technologies. All rights reserved.
Website:
www.p2wt.com
Email:
info@p2wt.com
Tel: (+852) 3905 1880
Fax: (+852) 3695 0820
Advertisement
Summary of Contents for P2 Wireless Technologies MeshRanger X32
- Page 1 X30 SERIES QUICK START GUIDE This guide is applicable for X32, X32e and X33 Published Oct 2016, Rev 0.4 P2 WIRELESS TECHNOLOGIES Copyright © 2016. P2 Wireless Technologies. All rights reserved. Website: www.p2wt.com Email: info@p2wt.com Tel: (+852) 3905 1880 Fax: (+852) 3695 0820...
-
Page 2: Setup Procedures
11. Click Sign in and start to configure the X30 with the SmartMoment Web user interface. For more information on how to configure the X30, please refer to the Product User Manual and the SmartMoment User Guide. Copyright © 2016. P2 Wireless Technologies. All rights reserved. Website: www.p2wt.com Email: info@p2wt.com... - Page 3 No PoE powered device is connected Steady – Green Radio0 (5GHz) is enabled Radio0 RADIO 0 (5GHz) Status Radio0 (5GHz) is disabled Copyright © 2016. P2 Wireless Technologies. All rights reserved. Website: www.p2wt.com Email: info@p2wt.com Tel: (+852) 3905 1880 Fax: (+852) 3695 0820...
- Page 4 (3) Insert two hexagon blots (item 1) with the flat washer and spring washer through the anchor bracket (item 2). Tighten the bolts on the hexagon nuts (item 4) with a torque value of 12-15 Nm (should not be greater than 20 Nm). Copyright © 2016. P2 Wireless Technologies. All rights reserved. Website: www.p2wt.com Email: info@p2wt.com...
- Page 5 Attach the mounting bracket to the X30 with four M8 hexagon bolts (item 1) with a torque value of 12-15 Nm. STEP 3: Attach the Mounting Bracket to a Pole Copyright © 2016. P2 Wireless Technologies. All rights reserved. Website: www.p2wt.com Email: info@p2wt.com...
- Page 6 (2) To adjust the horizontal angle, loosen the M8 hexagon nuts (item 2) and slowly adjust the angle of the bracket, then tighten it again at a torque value of 12-15 Nm. -End of Quick Start Guide- Copyright © 2016. P2 Wireless Technologies. All rights reserved. Website: www.p2wt.com Email: info@p2wt.com...
- Page 7 Federal Communications Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.