Advertisement
LBC Series
OPERATION ACTIVATION
The charger is starting in the Safe mode and after 30 seconds after the AC is applied it will do a battery test. If all is OK, then it will switch automatically to
the Charging mode. If the battery will be not recognized, the charger will stay in a Safe mode and it will wait for the next positive battery test. Only then it will
switch to the Charging mode.
If all necessary conditions for Charging mode are fulfilled, you can switch between the Charging and Safe modes by the Charging on/off command sent via
Ethernet or CAN communication. If any failure occurs, the charger goes to the Safe mode automatically. In this mode is the output voltage set below the
value allowed at Tmax (charging curve dependent, e.g. 105Vdc). The Safe mode is indicated by the LED, see Datasheet BCD.00821 for details.
INPUT POWER CONNECTOR X1 – PINOUT
SIGNAL NAME
PIN #
Earth
AC Line 1
L1
AC Line 2
L2
AC Line 3
L3
Connector type:
4-pin terminal block HDFK 10-HV/Z (Phoenix Contact)
Mating part:
Wires
OUTPUT POWER CONNECTOR X2
SIGNAL NAME
PIN #
CONSUMER+
BATTERY+
COMMON-
Connector type:
3-pin terminal block HDFK 50/Z (Phoenix Contact)
Mating part:
Wires
Fig. 2 Top View - Connectors Position
TYPE
Earth / Chassis
Input Power AC Fused
Input Power AC Fused
Input Power AC Fused
TYPE
Output Power DC
Output Power DC
Output Power DC_return
Asia-Pacific
+86 755 298 85888
© 2017 Bel Power Solutions & Protection
RECOMMENDED WIRES
Min. 4 mm
2
2
Min. 4 mm
2
Min. 4 mm
Min. 4 mm
2
RECOMMENDED WIRES
2
Min. 16/25 mm
2
Min. 16/25 mm
Min. 16/25 mm
2
Europe, Middle East
+353 61 225 977
3
V MAX
I MAX
528 Vrms (line to line)
14/21 Arms (per line)
V MAX
I MAX
137.5 VDC,
73/110 A
North America
+1 408 785 5200
BCM.00432_AD
Advertisement
