Summary of Contents for Ecolink Z-Wave Plus Smart
-
Page 1: Installation Guide
Z-Wave Plus Smart Switch Single Toggle A Universal Electronics Company Installation Guide © 2018 Ecolink Intelligent Technology Inc. PN STLS2-ZWAVE5... -
Page 2: Product Overview
No need to touch any (3) Remove the swith plate cover of the Z-Wave Plus Smart Switch with electrical wiring. the help of a flat head screw driver. - Page 3 Network Inclusion The Z-Wave Plus Smart Switch must be added to a Z-Wave Plus network prior to use. To include the device in a network both the device and the network controller must be in inclusion mode at the same time. Refer to the instructions provided by the manufacturer of your specific controller for details on initiating the controller’s...
- Page 4 Command Class Association Battery State This Z-Wave Plus Smart Switch has two Association groups of 1 node. The Z-Wave Plus Smart Switch will alert the user when the batteries Group one – Group one is the lifeline group. The Light Switch will send Switch Binary Reports with a value of 0x00 if the light is turned off and become low.
-
Page 5: Fcc Compliance Statement
Consult the dealer or an experienced radio/TV contractor for help. Manufacturer 0x014A Warning: Changes or modifications not expressly approved by Ecolink Intelligent Technology Inc. could void the user’s authority to operate the Product Type 0x00 06 equipment. This device complies with Industry Canada license-exempt RSS standard(s). -
Page 6: Limited Warranty
REQUIREMENTS OF THE INTENDED USE. any other warranty or liability concerning this product. It is recommended that the customer check their equipment on a regular basis for proper IN NO EVENT SHALL ECOLINK OR ANY OF ITS AFFILIATES BE LIABLE FOR ANY operation INCIDENTAL,...