MANUFACTURED IN ITALY TEL.+39.0571.675005 FAX.+39.0571.675013 Piccolo Italian Prestige Rigid Turntable Table Of Contents Congratulations & Introduction Box Content Construction Features Set-Up Instructions Positioning Operating the Piccolo Specifications Warranty, Customer Service & Warnings Troubleshooting Troubleshooting F.A.Q. Adjustment...
Page 4
VERY IMPORTANT Please read the following instructions carefully before installing your Bluenote I.A.V.® Turntable Piccolo Italian Prestige Rigid Turntable Congratulations I.A.V.® Thank you for having purchased an product. Introduction I.A.V.® I.A.V.® With products you enter a new dimension. is the new way of I.A.V.®...
INSTRUCTION BOOK AND WARRANTY CERTIFICATE Construction features This section describes the special features of the PICCOLO turntable, the construction features, the reasons for the technical choices and the originality of the design. PICCOLO is rigid turntable that it uses a board made in clear high -density polish ed acrylic obtained via “polymeric melting”.
Place t he Piccolo deck on a level surface you have chosen for it. We recommend a wall shelf, as they are the most sturdy, and immune to footfall, but a well made equipment rack should give satisfactory results also. Once the table deck is placed on your chosen set-up location you are now ready to continue.
12) The pulley on the Piccolo is a 2 -speed pulley. There are 2 grooves in the pulley. The top groove is for 33.3 rpm, and the lower groove is for 45 rpm.
33 1/3 rpm or 45 rpm By positioning the belt in the smaller groove of the synchronous pulley motor, the PICCOLO turntable be set at 33 1/3 rpm, while in the larger groove it will be set at 45 rpm. This posit ioning must be carried out manually.
BLUENOTE - I.A.V.® and the distribution agents operating within your territory decline responsibility of any kind. PS. The photos reproduced here refer to the Piccolo Turntable, but p arts and descriptions may vary from the product on sale without notice.
Warranty Certificate – Customer Service – Warnings Piccolo Italian Prestige Rigid Turntable Troubleshooting SYNPTOM DESCRIPTION CAUSE REMEDY • • BELT NOISE DURING The Green Belt makes a Because its low elasticity and If a quieter belt is requested PLAY (GREEN BELT)
2 hex bolts to know which one needs to be tighten more. Be careful not to tight the hex bolts to much anyway, the pulley threaded hex bolt holes could be damaged TROUBLESHOOTING Piccolo Italian Prestige Rigid Turntable SYNPTOM DESCRIPTION CAUSE REMEDY •...
TROUBLESHOOTING Piccolo Italian Prestige Rigid Turntable F.A.Q. Adjustment PICCOLO Turntable ACTION DESCRIPTION HOW TO DO ADJUST IT • • DUST COVER FRICTION The Dust Cover is hard or...
Page 13
• • tone The tone arm shaft is too big to get into the adjustable collar; ask your local dealer to have a custom made collar may fit such arm • • VTA tone arm is hard to Once the proper height of the arm is been adjust approximately reached, fix the shaft with just a hex bolt before screwing properly all the 3 hex bolts of the collar;...