Table of Contents
Advertisement
SeeSnake
4. Visually inspect the pushrod for cuts and abrasions. If
the outer jacket is cut or abraded through, the cable
should be replaced or repaired (re-terminated).
5. Inspect any other equipment being used per its in-
structions to make sure it is in good usable condition.
6. If any problems are found, do not use the unit until the
problems are corrected.
Work Area and Equipment
Set Up
Set up the SeeSnake System and work area ac-
cording to these procedures to reduce the risk of in-
jury from electrical shock, fire and other causes,
and to prevent damage to the SeeSnake System.
Always wear eye protection to protect your eyes
against dirt and other foreign objects.
1. Check work area for:
• Adequate lighting.
• Flammable liquids, vapors or dust that may ignite.
If present, do not work in area until sources have
been identified and corrected. The SeeSnake
System is not explosion proof. Electrical connec-
tions can cause sparks.
• Clear, level, stable, dry place for machine and op-
erator. Do not use the machine while standing in wa-
ter. If needed, remove the water from the work
area.
• Clear path to electrical outlet, if used for monitor,
that does not contain any potential sources of dam-
age for the power cord.
2. Inspect the work to be done If possible, determine the
drain access point(s), size(s) and length(s), pres-
ence of drain cleaning chemicals or other chemicals,
etc. If chemicals are present, it is important to under-
stand the specific safety measures required to work
around those chemicals. Contact the chemical man-
ufacturer for required information.
If needed, remove fixture (water closet, sink, etc.) to
allow access.
10
Find Quality Products Online at:
®
Standard and Mini Pipe Inspection Systems
WARNING
GlobalTestSupply
www.
3. Determine the correct equipment for the application.
The SeeSnake Standard System is made for:
• 2" to 12" lines up to 325' long.
The MINI System is made for:
• 1.5" to 8" lines up to 200' (61m) long.
4. Make sure all equipment has been properly inspected.
5. Evaluate the work area and determine if any barriers
are needed to keep bystanders away. Bystanders
can distract the operator during use. If working near
traffic, erect cones or other barriers to alert drivers.
Positioning
Properly positioning the equipment and pushing of the
cable will save time, be more comfortable and mini-
mize the potential for equipment damage. You can lay
the system on its back supports for even greater stabil-
ity. This is also preferred when on a rooftop (entry
through a roof vent), overhead entry or hillside.
Figure 22 – Reel Can Be Positioned On Its Back For
Greater Stability
Place the reel so the pushrod is easy to manage as you
push the camera through the line – about 3' to 5' (1-2 me-
ters) from the entry. This will provide ample cable to
grasp and will develop momentum without having a lot of
slack dragging on the ground. Slack can be alleviated by
putting friction on the reel using the brake. Set up the
Camera Control Unit (CCU) in an area where it is stable
and can be viewed while you are pushing the camera.
The location should not be wet or allow the monitor to get
wet and should be close enough that its controls are
easy to reach during use. In brightly lit areas, point the
monitor screen away from bright light sources and/or
use the monitor's sun shade to reduce glare.
Connections
1. Connect the Camera Control Unit to an AC outlet if
needed and press the reset button on the GFCI if pro-
vided.
Ridge Tool Company
.com
sales@GlobalTestSupply.com
Advertisement
Table of Contents
