3Bays GSA PUTT User Manual page 16

For Android users
A: Please make sure:
1) Make sure Bluetooth is enabled.
2) Blue & Red LED are alternating by pressing and holding power button for 4 seconds from OFF mode before
you start the pairing process.
3) You are not holding the pin of 3BaysGSA PRO device during the pairing process.
Q2: I can't search my 3BaysGSA PUTT device on the Bluetooth setting.
A: Please reboot your mobile and try the pairing procedures again.
Q3: After I Putting, the Blue LED of the device doesn't flash quickly and transmit data.
A: You may have some practice Putting movements at the setup position before you actually swing. Please keep
your club still at the setup position for 2 seconds before Putting. (Blue LED is on and ready to Putting )
Q4: After I Putting, 3BaysGSA PUTT starts transmitting the data to the mobile but it stops without data
transmission complete.
A: 3BaysGSA PUTT device may be at low battery level. Please charge the device for an hour (when Blue LED is on,
it is fully charged ) and then you can Putting again.
Q5: After I swing, 3BaysGSA PUTT does not flash quickly and transmit data.
A: 3BaysGSA PUTT device may be at low battery level, please charge the device for a hour.
Q6: Blue LED never goes on during setup position even I keep my club still.
A: The 3BaysGSA PUTT device may not be applied correctly on the end of your club Please align the arrow
on 3BaysGSA PUTT device with the mark of the golf grip, which is pointing to the square club face.
15