Advertisement
6. MAINTENANCE
WARNING! Ensure that the grinder is disconnected from the mains power supply before attempting any maintenance.
6.1
Cleaning
6.1.1
Keep the grinder ventilation slots clean and free from obstructions. If available, blow compressed air into the vents to clear any internal
dust (safety goggles must be worn when undertaking this process). Keep the outer case of the grinder clean and free from grease.
DO NOT wash with water or use solvents or abrasives.
6.2
Changing the motor brushes (SG101.V2, SG115.V2)
6.2.1
Remove the screw at the rear of the grinder then pull the rear body casing away.
6.2.2
Release the brush assembly cap as in fig.9.
6.2.3
Remove the brush assembly and replace.
6.2.4
Refitting is a reversal of the above procedure.
6.2.5
Repeat for the second brush on the other side of the grinder.
6.3
Changing the motor brushes (SG125, SG2303.V2)
6.3.1
Remove the screw from the side panel half way up
the grinder, then remove panel
6.3.2
Release the tension spring from the carbon brush
and slide it out of the brush holder. (fig.10)
6.3.3
Replace the motor brush.
6.3.4
Refitting is a reversal of the above procedure.
6.3.5
Repeat for the second brush on the other side of the
grinder.
fig.10
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
www.sealey.co.uk
01284 757500
Web
sales@sealey.co.uk
01284 703534
email
SG101.V2, SG115.V2, SG125, SG2303.V2
fig.9
Issue: 2 - 16/02/10
Advertisement
