Page 2
Thank you for choosing SPRINT GPS cycling computer With low power consumption 2.7 inches HD screen More than 30 hours of battery life Integrated accelerometer, geomagnetic Temperature and air pressure sensors Support all bluetooth and ANT+ sensors...
QUICK SETUP Step 3: Initial setting Step 1: Charging Before you use SPRINT for the first time, you need to do Take out the USB cable and connect to a standard 5V some initial settings. Following the instructions on your USB adapter, SPRINT will turn on automatically.
• At data page(figure 1) you can long press the GPS signal Sensor connection side button + to switch backlight mode. ① Strong signal Speed ② Good signal Cadence ⑥ ③ Start Weak signal Heart rate Sync ④ No signal Power Menu ⑤...
3 Use the 2.5mm hex wrench to tighten the screw; speed, calibrate time, record mileage and tracks etc. 4 Align the tabs on the back of the SPRINT with the bike After start recording, please make sure to be outdoors mount notches, then press down slightly and turn the and no shelter above.